DIGITAL Instructions #1056501 Product #710909 CONTENTS: Digital F.A.T. Wrench® 9 drive bits 1 square drive adapter 1 Spare battery Storage case sales@btibrands.com Rev.
The Wheeler® Engineering Digital F.A.T. Wrench® is a hand driven torque wrench with a digital LCD that is very useful for applying the necessary torque to most firearm and firearm accessory fasteners. The Digital F.A.T. Wrench® features an ergonomic rubber overmolded handle, a standard ¼” hex drive tip, and can be used to apply torque from 15-100 lb-in at 0.1 lb-in increments. Units of measurement can be changed from lb-in to kg-cm or N-m. The digital display is capable of two different modes.
NOTE: Holding at the target torque setting will cause the speaker to draw more power and may result in premature low battery life. NOTE: It may be difficult for the hearing impaired to detect the high frequency tone produced by the internal speaker. Using the value displayed on the LCD is the best method to confirm accurate torque application. 8. After use, the Digital F.A.T. Wrench® should be turned off and placed in its protective case.
BATTERY AND REPLACEMENT F.A.T. Wrench® The Digital uses a CR 2032 Lithium coin battery. To replace the battery: 1. Unscrew the 4 screws holding the battery compartment door closed 2. Remove old battery 3. Replace with new battery 4. Replace cover and screw down snug. NOTE: DO NOT OVER TIGHTEN SCREWS. ONLY HAND TIGHTEN THE 4 COVER SCREWS. Battery Compartment Battery Compartment Cover TIPS • • • • • F.A.T.