Instructions / Assembly

WG Wood Products
Installation Instructions
For additional help or to watch an installation video for in-the-wall
products, visit our website at www.wgwoodproducts.com
1. Using the screws provided, screw the
magnetic latch into the top of the curio
cabinet housing
2.2. Insert the black pivot washers into the holes in the bottom and top of the curio
cabinet. (Arch Top Curios –skip this step). Stick the metal plate to the back of the
glass where the hinges will go. Insert the glass into the bottom hinge and screw it
down. Do Not overtighten as glass breakage could occur). Insert that hinge into
the pivot washer at the bottom of the cabinet. Repeat the procedure at the top of
the glass, but put the hinge into the pivot washer first, then slide the glass into it
and tighten the screws.
3. Attach the metal magnetic strike plate to the top of
the glass to match up to the magnetic latch Peel and
stick the foam to the glass by centering if over the
edge of the glass and pressing it down on each side,
then push the metal strike plate down on top of the
foam.
4. MIRROR BACK OPTION ONLY: Lay the mirror inside the
back of the abinet and attach the mirror to the back of the
cabinet using the clips and screws provided. Be careful not
to overtighten the clip or mirror breakage will result. They
only need to be secure enough to hold it in place. If you do
not have room in your opening for the clips/screws, an
alternative method to mount the mirror back is to lay the
mirror back on the back of the unit and use duct tape all the
way around to strap it down. This method is every bit as
effective and secure, yet takes up no extra space like the clips
and screws do.,
Curio Cabinets ONLY: