Instructions / Assembly

WG Wood Products
Installation Instructions
If you have ordered optional concealed hinges:
For additional help or to watch an installation video for in-the-wall
products, visit our website at www.wgwoodproducts.com
The Blum concealed hinges have two pieces to them (the hinge and the mounting plate). Begin by installing
the hinges on the door. This is the piece with the round cup. There will be two Truss head screws (rounded
head) to screw this into place. Push the hinge into the pre-drilled opening and straighten it up. The clip with
the screw should be hanging over the edge of the door when you’re done. Next attach the mounting plate to
that clip by sliding it onto the back side of the clip until it stops. (If by chance you accidentally close the
hinge, you can reopen it by prying it back up with a screwdriver. It has a tight spring because they are self
closing hinges. Once the mounting plate is screwed into place, place the door and mounting plates onto the
cabinet frame and screw it into the cabinet frame using the two flat head screws provided. A second set of
hands holding the door will help with this process.
Our doors are set up with ½” overlay on nearly every product. So this means that the door will be ½” larger all
the way around than the opening it’s covering. So when placing your door, be sure to have it overlap ½” at the
top and bottom.
Alternatively, you can also set the door and mounting plates in place and mark where the screws go. Then
you can disconnect the hinge from the mounting plate, screw the mounting plate to the cabinet and reconnect
the hinges. Tighten the screw on each hinge at the connection and you’re done.