Owner's Manual

Speaker/RGB wires may be inserted from the top of the Pod
through the center of the Swivel Flange & Bottom clamp, then
through a hole in the mounting surface or pipe.
To run the wires without drilling a hole in the surface or pipe, there
is a pre-scored area on the side of the Swivel Flange & the bottom
clamp to remove, allowing the wires to pass through.
Top Clamp
Bottom Clamp
Swivel Flange _.
To mount the pod to a
flat deck, remove the
2 Phillips head screws
holding the swivel flange
to the bottom clamp,
then insert screws
through the swivel
flange into the flat area.
Top & bottom clamp will
not be used when flat
deck mounting.
Fork must be inserted to
attach the pod to the
bottom of t7amp.
'
I
Screw is tightened with a 5mm Allen
wrench after the swivel is adjusted.
Wet Sounds RECON 6 POD Enclosed Speaker System. Operations / Installation Manual