W westwood design Assembly Instructions Jonesport Dressing Combo
! WARNING: FALL HAZARD § TO PREVENT DEATH OR SERIOUS INJURY, ALWAYS KEEP CHILD WITHIN ARM’S REACH. § THIS PRODUCT IS NOT INTENDED TO BE USED AS A CHANGING TABLE UNLESS EQUIPPED WITH AN APPROVED CHANGING PAD THAT MEETS ASTM F2388-06. USE OF THE PRODUCT WITHOUT THIS MAY RESULT IN DEATH OR SERIOUS . INJURY TO YOUR CHILD FROM FALLING. THE MAXIMUM WEIGHT OF THE OCCUPANT MAY NOT EXCEED 30 LBS. (13.6 kg). § THE CHANGING PAD MAY NOT EXCEED 44 IN. (1115 mm) IN LENGTH OR § 18 IN. (455 mm) IN WIDTH.
Congratulations on your purchase of a Westwood product. We take great pride in the quality and design of our furniture. The safety of your child is our highest priority. It is important that you read these instructions carefully and completely to ensure that this product functions as it was designed. After opening the package, check to see that all the parts are present. If you think something is missing, please contact your retailer, and they can arrange to have the missing parts quickly replaced.
Step 1 A. Unpack all the components from the packaging. The feet are located in the drawer. B. Flip the combo over onto its top and insert the threaded end of the foot into the angled bracket as shown. Add a metal washer (D), a lock washer (E), then the nut (F), and tighten securely with the wrench (K). Repeat for the other bolt, then repeat for the other 3 feet.
Step 2 A. Align the holes in the galley rail sides (B) with the holes in the galley rail back (A). B. Place a nylon washer (H) onto a bolt (G), then thread it through the hole. Tighten securely using the allen wrench (J). Repeat for the other hole. C. Repeat for the other side.
Step 3 A. If you are using a changing pad, secure it to the combo using the straps as instructed by the pad manufacturer. B. Center the galley rail on the top, then screw the wood screws (I) through the holes on the mounting plates and into the combo. Wood Screw (I) W westwood design 635 N. Billy Mitchell Rd., Ste. B Salt Lake City, UT 84116 Phone: 1-908-719-4707 support@westwoodbaby.
Step 4 A. Insert the shelf tabs (M) into the holes on the inside of the door, and carefully lower the shelf (L) onto the tabs. B. If desired, you can screw ½” long wood screws (not included) through the holes in the bottom of the shelf tabs into the bottom of the shelf to prevent the shelf from being accidentally removed. Shelf Tab (M) W westwood design 635 N. Billy Mitchell Rd., Ste. B Salt Lake City, UT 84116 Phone: 1-908-719-4707 support@westwoodbaby.
