Product Manual

ManualsBrandsWestinghouse ManualsAll Ovens60cm Built-In Oven

6 INSTALLING YOUR APPLIANCE

• If a powerpoint is fitted it must be accessible with the

appliance installed, as the plug must be accessible

after installation.

• This appliance must be mounted on a flat surface for

the full width and depth of the product.

• To avoid overheating, the appliance must not

be installed in a recess or cupboard behind a

decorative door.

Hard wiring detail

1. Remove terminal cover plate from rear panel

of appliance.

2. Fit wires through hole in cover plate and make

connections to terminals.

3. Engage wires into plastic clip. Secure plastic clip with

two long silver screws (supplied in separate bag).

4. Replace cover plate onto rear panel.

553mm

15mm

8mm min

clearance

Second active wire only

required (optional) for

multi-phase products

Plastic clips

Plastic clip

securing points

Cabinet construction for your appliance

For the best integration within a kitchen, install the

appliance in a standard 600mm wide cupboard that gives

a flush fit with the surrounding cupboard fronts as shown

in Fig. A. A recess of 20 mm is ideal.

With the exception of pyrolytic ovens, the appliance can

also be installed using a proud fit to the surrounding

cupboard as shown in Fig. B.

WARNING

CAUTION

For all Pyrolytic clean oven models, the oven must be

installed as a flush fit to the surrounding cupboards and

the “Infill panel” MUST not exceed 100mm in length. This

ensures a 16mm gap is maintained between the cabinet

and oven side to prevent the cupboard overheating.

Fig. A

Flush Fit

16mm

568mm

600mm

20mm

Infill

panel

Cupboard

door

Oven

100mm max

for Pyro

oven

Fig. B

Proud Fit