Dimension Sheet

ManualsBrandsWestinghouse ManualsCooking Appliances44L Built-in Combination Microwave and Oven 900W Dark SS

Dimension and installation guide

IMPORTANT

These dimensions are a guide only. All measurements are in millimetres (mm).

For complete installation instructions, refer to the manual provided with product.

westinghouse.com.au

Built in microwaves

WMB4425SC, WMB4425DSC

Product WxHxD (mm) 596 x 454 x 568

Flush mount cut-out WxHxD (mm) 600 x 466 x 570

15INSTALLATION

WARNING

CAUTION

Do not block the air vents. If you do that, the appliance

can overheat.

WARNING

CAUTION

Do not connect the appliance to adapters or extension

leads. This can cause overloading and risk of fire.

• Model WMB4425DSC is for built-in use only.

• The fitted cabinet must not have a back wall behind

the appliance.

• Put the appliance far away from steam, hot air and

water splashes.

•

If the appliance is stored/ transported at sub-zero

temperatures, do not activate it immediately after

installation. Allow at least two hours for it to be brought

up to room temperature before turning on the unit.

Installation - Built-in model WMB4425DSC

For the best integration within a kitchen, install this

appliance in a standard 600mm wide cupboard that gives

a flush fit with the surrounding cupboard fronts. A recess

of 20mm is ideal.

The built-in cabinet must not have a rear wall behind

the appliance. Do not cover ventilation slots and air

intake points.

NOTE: Your appliance must be mounted on a flat surface

for the full width and depth of the product.

Built-in furniture – flush fit

600mm

466mm

(+6)

Min.

570mm

45mm

Min airflow gap

at front 50mm

A 45mm ventilation gap must be left between the built-in

cabinetry and wall with no back panelling on the cabinet

housing the microwave oven. A minimum ventilation gap

of 3.5mm must be left between the bottom of the front

trim and adjacent shelf/cupboard.

Failure to accommodate for this gap in the installation

can cause product malfunctions which are not covered

under warranty

Side view

45mm

6mm packer

Please note

packer must be

set back 20mm

from front trim to

avoid obstruction

of front vent.

Packer must be

secured to base

of cabinet.

microwave

oven

20mm

External face

of cabinet

and/or door

Min 3.5mm

ventilation

gap below

trim

Min airflow gap

at front 50mm

Flush fit top view

infill panel

350mm max. length

20mm

600mm

Cupboard

door

Cupboard

door

Infill panels are recessed 20mm from the external cabinet

door to accommodate flush fit.

INSTALLATION

568

454

596

570

600

466