User's Manual
Table Of Contents
- Preface
- 1 Product Overview
- 2 Optimizing the System during Installation
- 3 Web-Based GUI
- 3.1 Web-Based GUI Session
- 3.2 System Status
- 3.3 Local Network
- 3.4 RF Configuration
- 3.5 Program a Filter
- 3.6 Remote Network
- 3.7 SNMP Configuration
- 3.8 Time Configuration
- 3.9 System Health
- 3.10 Install and Upload
- 3.11 Reboot
- 3.12 Alarm Configuration
- 3.13 Email Configuration
- 3.14 Log Configuration
- 3.15 Account Credentials
- 4 Console Interface
- 4.1 Text Menu Interface (Local Access)
- 4.2 Telnet Session (Remote Access)
- 4.3 Modem Interface (Remote Access with Login)
- 4.4 Additional Tips
- Appendix A Attenuation and Dynamic Range Guidelines
- Appendix B Band Plans and Filter File Naming Conventions
- Appendix C Mechanical Configurations
- Appendix D Mechanical and Electrical Specifications
- Appendix E Port Configurations
- Appendix F Acronyms and Abbreviations
Digital Repeater Line
DSP95 Series User’s Guide
Page 73 of 74
WESTELL.COM
1.877.844.4274 © 2016 Westell Technologies
25 May 2016 Doc. No. 960-1250-MNL rG
Appendix F Acronyms and Abbreviations
Table F-1 is a list of acronyms and abbreviations used in this manual.
Table F-1: Acronyms and Abbreviations
Acronym/Abbreviation
Definition
AGC
Automatic Gain
Control
APC
Automatic power
control
AUI
Attachment
Unit Interface
CPU
Central Processing
Unit
DAS
Distributed Antenna System
DHCP
Dynamic Host Configuration Protocol
DSP
Digital Signal Processing
EEPROM
Electrically Erasable Programmable Read Only
Memory
EIA
Electronic Industries Association
ERP
Effective Radiated
Power
FCC
Federal Communications Commissions
FCS
Feedback
FPGA
Field P
rogrammable Gate
Array
GUI
Graphical User Interface
LED
Light Emitting Diode
OIP3
Third-Order Intercept
Point
RF
Radio Frequency
RBW
Resolution Bandwidth
SBC
Single Board
Computer
SNMP Simple Network Management Protocol
SSH Secure Shell, Network Protocol
TMI
Text
Menu
Interface
UHCI
Universal Host Controller
Interface
USB
Universal Serial Bus