User Manual

8 960-0110-003 Rev C
05/08/01
If coordinates are not available, measure the RSSI at the outside antenna
output by connecting a phone to the outside antenna and slowly rotating the
antenna until a maximum reading is obtained.
The Mini-IBA and inside antenna should be centrally located, keeping
coaxial cable runs to a minimum. A maximum length of 100 feet of low loss
cable is recommended. The actual coax used should be RG-8 type with a
flame retardant rating as a minimum. If the coax is run through an area
where heating and/or cooling air is channeled, a plenum rated coax should
be used. When mounting the amplifier, take care to avoid areas of high heat
or extreme cold. In general, do not place the unit on or near the top of high
ceilings, by heaters or in cold storage areas.
During installation, care must be taken to provide the maximum isolation
between inside and outside antennas. This isolation should be in the order of
70 dB to prevent any re-generative feedback in the system. Feedback of this
nature may cause the amplifier to emit a continuous signal at maximum
amplitude and could, in some cases, interfere with the normal operation of
the cell site.
There are no installation or user adjustments or tuning on this unit.