WS5123KU.
8 1 7 2 5 6 4 3 9 10 11 12
1 3 4 2 Fig.A2 Fig.A1 1 5 3 2 Fig.B1 Fig.A3 1 5 4 2 Fig.C1 Fig.B2 ON 3 Fig.C2 Fig.
Fig.C2 Fig.D Fig.E Fig.F Fig.
PRODUCT SAFETY WARNING: Some dust created by power sanding, sawing, grinding, drilling and other construction activities contains chemicals known to the state of California to cause cancer, birth defects or other reproductive harm. Some examples of these chemicals are: • Lead from lead-based paints; • Crystalline silica from bricks and cement and other masonry products； • Arsenic and chromium from chemically-treated lumber.
g) h) be caught in moving parts. If devices are provided for the connection of dust extraction and collection facilities, ensure these are connected and properly used. Use of dust collection can reduce dust-related hazards. Do not let familiarity gained from frequent use of tools allow you to become complacent and ignore tool safety principles. A careless action can cause severe injury within a fraction of a second. 4. a) POWER TOOL USE AND CARE Do not force the power tool.
COMPONENT LIST 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. Tool-less blade change lever On/off switch Variable speed Handing area Venting slots Flange Accessory interface Sight light Plunge cut saw blade Circular segment saw blade Sanding sheet Sanding pad * Not all the accessories illustrated or described are included in standard delivery. TECHNICAL DATA Type WS5123KU.1 (51 - designation of machinery, representative of Sonicrafter) Rated voltage Power input 120V~60Hz 2.
OPERATION INSTRUTIONS NOTE: Before using the tool, read the instruction book carefully. INTENDED USE The power tool is intended for sawing and remodelling wooden materials, plastic, plaster, non-ferrous metals and fasteners (e.g. nails and clamps) as well as for working on soft wall tiles and for dry grinding of small surfaces. It is especially suitable for working close to edges and for flush cutting. 1. MOUNTING ACCESSORIES CAUTION: For all work or when changing accessories, always wear protective gloves.
cutting or sanding finish. Start your tool before working and turn it off only after you stop working. Do not start sanding without having the sandpaper fitted. Do not allow the sandpaper to wear away, it will damage the sanding pad. The guarantee does not cover sanding pad wear and tear. Use coarse grit paper to sand rough surfaces, medium grit for smooth surfaces and fine grit for finishing surfaces. If necessary, first make a test run on scrap material.
