WS4151U.1 (PPS240BU 2.
2 1 9 3 8 4 7 6 5 10 7 Fig.A Fig.B Fig.C Fig.
Fig.D Fig.C 11 1 Fig.E Fig.G Fig.
PRODUCT SAFETY WARNING: Some dust created by power sanding, sawing, grinding, drilling and other construction activities contains chemicals known to the State of California to cause cancer, birth defects or other reproductive harm. Some examples of these chemicals are: • Lead from lead-based paints; • Crystalline silica from bricks and cement and other masonry products; • Arsenic and chromium from chemically-treated lumber.
extraction and collection facilities, ensure these are connected and properly used. Use of dust collection can reduce dust-related hazards. h) Do not let familiarity gained from frequent use of tools allow you to become complacent and ignore tool safety principles. A careless action can cause severe injury within a fraction of a second. 4) Power tool use and care a) Do not force the power tool. Use the correct power tool for your application.
COMPONENT LIST 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. ON-OFF switch Palm grip handle Dust box Base plate Clamp lever Clamp lever lock Sanding paper* (See fig. A) Sand paper clamp Motor housing Paper punch* (See fig. B) Vacuum adaptor* (See fig. E) * Not all the accessories illustrated or described are included in standard delivery. TECHNICAL DATA Type Designatio WS4151U.
OPERATING INSTRUCTIONS NOTE: Before using the tool, read the instruction book carefully. 1. CHANGING THE SANDING PAPER (See Fig. A) To fit new sanding paper, lift up the clamp lever out of clamp lever lock to loosen the paper clamp (8), then insert approximately 3/16”(5mm) of one end of the sanding paper under the sanding paper clamp (8) until the paper contacts the housing wall. Lift up the clamp lever (5) and move it to the lever lock position.
grit for smooth surfaces and fine grit for the final surfaces. If necessary, first make a test run on scrap material. Use only good quality sandpaper. The sandpaper controls the sanding efficiency, not the amount of force you apply to the tool. Excessive force will reduce the sanding fficiency and cause motor overload. Replacing the sandpaper regularly will maintain optimum sanding efficiency.
