WS2939U (CID18GW) Cordless impact driver 2 EN
8 1 7 2 3 6 4 5
100% 0% Fig.A1 Fig.A2 Fig.B1 Fig.B2 a 1 a 2 2 Fig.C1 Fig.C2 Fig.D1 Fig.
Fig.D1 Fig.D2 1 2 Fig.E Fig.F Fig.G1 Fig.
PRODUCT SAFETY WARNING: Some dust created by power sanding, sawing, grinding, drilling and other construction activities contains chemicals known to the state of California to cause cancer, birth defects or other reproductive harm. Some examples of these chemicals are: • Lead from lead-based paints; • Crystalline silica from bricks and cement and other masonry products; • Arsenic and chromium from chemically-treated lumber.
moving parts. Loose clothes, jewellery or long hair can be caught in moving parts. g) If devices are provided for the connection of dust extraction and collection facilities, ensure these are connected and properly used. Use of dust collection can reduce dust-related hazards. h) Do not let familiarity gained from frequent use of tools allow you to become complacent and ignore tool safety principles. A careless action can cause severe injury within a fraction of a second.
SAFETY WARNINGS FOR BATTERY PACK a) Do not dismantle, open or shred battery pack. b) Do not expose battery pack to heat or fire. Avoid storage in direct sunlight. c) Do not short-circuit a battery pack. Do not store battery packs haphazardly in a box or drawer where they may short-circuit each other or be short-circuited by other metal objects.
SYMBOLS To reduce the risk of injury, user must read instruction manual Warning Wear ear protection Wear eye protection Wear dust mask Batteries may enter water cycle if disposed improperly, which can be hazardous for ecosystem. Do not dispose of waste batteries as unsorted municipal waste. Do not burn Li-Ion battery, battery must be recycled POSITEC Inc. has established a partnership with the RBRC Corporation to recycle any Positec batteries with the RBRC-call2recycle seal.
COMPONENT LIST 1. 2. 3. 4. 5. 6. 7. 8.
OPERATION INSTRUCTIONS NOTE: Before using the tool, read the instruction book carefully. INTENDED USE The tool is intended for driving in and loosening screws as well as for drilling in wood, metal and plastic. BEFORE PUTTING INTO OPERATION 1. CHARGING THE BATTERY NOTE: a) Do not use any charger other than that specifically provided for use with the equipment. b) If the battery pack is very hot you must remove your battery pack from the charger and allow time for the battery to cool down before recharging.
6. USING THE LED To turn on the light, press the on/off switch and make sure the forward/reverse rotation control is on right/left position. When you release the on/off switch, the light will be off. LED lighting increases visibility-great for dark or enclosed area. For Battery tools The ambient temperature range for the use and storage of tool and battery is 0 oC (44.6 oF)-45oC (113 oF). The recommended ambient temperature range for the charging system during charging is 0 oC (44.6 oF)-40 oC (104 oF). 7.
