Use and Care Manual

ASSEMBLY

STEP 1: ASSEMBLING THE STAND (Fig. 1)

1. Place the 4 top braces upside down on a flat sur-

face to form a rectangle.

2. Attach the 4 legs to the top braces using (16) M8-

1.25 x 12 carriage bolts and (16) M8-1.25 lock nuts.

The legs should be on the outside of the braces.

Hand tighten all fasteners.

NOTE: There are two types of corner legs: one

type with handle-mounting holes just below the up-

per support mounting holes, the other with wheel-

mounting holes on the bottom of each leg. Make

sure that the short braces connect legs of matching

styles.

3. Attach the 4 bottom braces to the lower brace

mounting holes of the 4 legs with the remaining (16)

M8-1.25 x 12 carriage bolts and (16) M8-1.25 lock

nuts. Hand tighten all fasteners.

4. Slide the 4 feet pads onto the bottom of the 4 legs.

5. Turn the stand over, square up the braces and

legs, then fully tighten all fasteners using a crescent

wrench or ratcheting socket wrench.

Feet Pads (x4)

Long Top Braces (x2) Short Top Braces (x2)

Short Bottom Braces (x2)

Long Bottom Braces (x2)

M8-1.25 x 12

Carriage Bolts (x32)

M8-1.25

Lock Nuts (x32)

Legs (x2)

Fig. 1

WARNING: To avoid injury from accidental startups, do not plug in the drum sander until all assembly

and preparation procedures have been completed.

Wheel Mount Legs

Handle Mount Legs