User's Manual

35. Attach the loop on the end of the Low Pulley Cable

(75) to the indicated hole in the Small Leg Lever (41)

with a 3/8” x 2 3/4” Bolt (46), two 3/8” Flat Washers

(48), and a 3/8” Nylon Jamnut (63).

36. Remove a Pro Pulley (26) from the bag marked

Pulley Bag 2.

Identify the Press Cable (72). It is approximately 389

1/2” long with a ball on one end and a threaded shaft

on the other. Begin by attaching the end with the ball.

Wrap the Press Cable (72) around a Pro Pulley (26)

in the direction shown. Attach the Pulley to the indi-

cated hole in the Press Top Frame (9) with a 3/8” x

3 1/2” Bolt (56), a 3/8” Flat Washer (48), and a 3/8”

Nylon Jamnut (63). Make sure the Cable is between

the Pulley and the welded pin on the Press Top

Frame.

37. Route the threaded end of the Press Cable (72)

around the 3 1/2” Pulley (24) that is already mounted

on the Top Frame (9).

38. Wrap the Press Cable (72) around a 3 1/2” Pulley (24)

in the direction shown. Attach the Pulley to the indicat-

ed hole in the Press Upright (2) with a 3/8” x 3 3/4”

Bolt (59), a 3/8” Flat Washer (48) and a 3/8” Nylon

Locknut (50). Make sure the Cable Trap is oriented

as shown.