User manual

ManualsBrandsWeber ManualsGrillGenesis 2300 NG

 WARNING

If the information in this manual is not

followed exactly, a ﬁ re or explosion may

result causing property damage, personal

injury or loss of life.

• Do not store or use gasoline or other

ﬂ ammable vapors and liquids in the

vicinity of this or any other appliance.

- WHAT TO DO IF YOU SMELL GAS:

• Do not try to light any appliance.

• Do not touch any electrical switch; do

not use any phone in your building.

• Immediately call your gas supplier from

a neighbor’s phone.

• Follow the gas supplier’s instructions.

• If you cannot reach the gas supplier, call

the ﬁ re department.

- Installation and service must be performed

by a qualiﬁ ed installer, service agency or

the gas supplier.

 WARNING

Improper installation, adjustment,

alteration, service or maintenance can

cause injury or property damage. Read the

installation, operating and maintenance

instructions thoroughly before installing

or servicing this equipment.

39995 US 03/16/05

WEBER

FLAME

#39995

Natural Gas Fireplace Owner’s Guide

 WARNING: FOR OUTDOOR USE ONLY.

These instructions are to be retained by the

consumer for future reference.

This appliance is not a heater.

Summary of content (20 pages)

PAGE 1
WEBER FLAME TM Natural Gas Fireplace Owner’s Guide #39995 WARNING If the information in this manual is not followed exactly, a fire or explosion may result causing property damage, personal injury or loss of life. • Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. - WHAT TO DO IF YOU SMELL GAS: • Do not try to light any appliance. • Do not touch any electrical switch; do not use any phone in your building.
PAGE 2
DANGERS AND WARNINGS DANGER Failure to follow the Dangers, Warnings and Cautions contained in this Owner’s Manual may result in serious bodily injury or death, or in a fire or an explosion causing damage to property. WARNINGS Do not use this appliance to cook food. NEVER burn real logs in fireplace. Do not burn any other materials than are supplied with and intended for use in this fireplace. Do not pour water into fireplace. Do not use this appliance if any part has been under water.
PAGE 3
WARRANTY / GENERAL INSTRUCTIONS Weber-Stephen Products Co. (Weber®) hereby warrants to the ORIGINAL PURCHASER of this Weber® gas fireplace that it will be free of defects in material and workmanship from the date of purchase as follows: Aluminum Castings, lifetime, Porcelain Hood Section, Burner, Igniter, All Remaining Parts, 1 year paint 25 years 10 years 3 years 3 years • These instructions will give you the minimum requirements for assembling your Weber® gas fireplace.
PAGE 4
GENERAL INSTRUCTIONS Use of this Weber® fireplace with LP (Liquid Propane) will void all product warranty and can result in a fire or explosion, which can cause serious bodily injury, death, and damage to property. • • Do not use with charcoal fuel or any other solid fuel. Check that the burner ports are free from debris that might obstruct the flow of combustion or ventilation air. The areas around the natural gas supply must be free and clear from debris.
PAGE 5
PARTS LIST BASE - 1 CERAMIC LOGS - 8 BACK PANEL - 1 HOOD VENT - 1 RAIN SHIELD - 3 HOOD VENT SUPPORT - 4 HOSE - 1 1/4 - 20 1/2” CARRIAGE BOLT - 16 1/4 - 20 1/2” NUT - 16 SUPPORT BRACKET - 3 LAVA ROCKS 7/16” (11 MM) WRENCH - 1 5
PAGE 6
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 EXPLODED VIEW
PAGE 7
EXPLODED VIEW LIST 1. HOOD VENT 16. IGNITER BOX ASSEMBLY 2. 1/4 - 20 X 1/2” CARRIAGE BOLT 17. HUBCAP 3. SUPPORT BRACKET 18. BURNER PLATE 4. QUICK-DISCONNECT HOSE 19. CONTROL PANEL 5. 1/4 - 20 X 1/2” NUT 20. BURNER PLATE LEG 6. HOOD VENT SUPPORT 21. FIREBOX 7. RAIN SHIELD 22. LEG 8. REAR PANEL 23. NAMEPLATE ASSEMBLY 9. WASHER 24. IGNITER ASSEMBLY 10. 1/4 - 20 X 1/2” KEPS NUT 25. CONTROL KNOB 11. GAS TRAIN ASSEMBLY 26. 1/4 - 20 1/2” CARRIAGE BOLT 12. WHEEL COVER 13. WHEEL 14.
PAGE 8
ASSEMBLY Assembly: Consumer - 40 Minutes. 1 *Professional - 30 Minutes. 2 4 ( ) Hand tighten only. 3 2 ( Hand tighten only. ) 4 2 ( Hand tighten only.
PAGE 9
ASSEMBLY 5 4 ( ) Hand tighten only. 6 Warning text on panel faces outward.
PAGE 10
7 ASSEMBLY 4 ( ) 8 1 2 Wrench tighten ALL nuts at this time. 9 Empty lava rocks onto cardboard packing. Remove small debris. Do not empty bag of lava rocks directly into the fireplace. Doing so could cause the burner ports to clog. 10 Do not obstruct ignition box.
PAGE 11
ASSEMBLY 11 Place ceramic logs in fireplace. NEVER burn real logs in fireplace. 12 11 Always attach rain shields when not in use and for storage. 13 DANGER Do not operate fireplace untill ALL rain shields have been removed. Failure to do so could result in a fire or explosion which can cause serious bodily injury or death, and damage to property.
PAGE 12
GAS INSTRUCTIONS INSTALL GAS SUPPLY General Specifications for Piping Note - Contact your local municipality for building codes regulating outdoor gas fireplace installations. • Refer to AS5601 gas installations for piping and hose requirements. • Refer to AS5601/AG 601, local authority, gas, electric, and other relevant statutory regulations for use and installation. • WE RECOMMEND THAT THIS INSTALLATION BE DONE BY A PROFESSIONAL.
PAGE 13
GAS INSTRUCTIONS DANGER Do not use an open flame to check for gas leaks. Be sure there are no sparks or open flames in the area while you check for gas leaks. This will result in a fire or explosion which can cause serious bodily injury or death and damage to property. a SIDE VIEW (1) CHECK THAT THE BURNER VALVE IS OFF Valve is shipped in the OFF position, but you should check to be sure that it is turned OFF. Check by pushing down and turning clockwise. If it does not turn, it is off.
PAGE 14
GAS INSTRUCTIONS CHECK FOR GAS LEAKS (1) DANGER Do not use an open flame to check for gas leaks. Be sure there are no sparks or open flames in the area while you check for leaks. Sparks or open flames will result in a fire or explosion which can cause serious bodily injury or death and damage to property. (2) WARNING: You should check for gas leaks every time you disconnect and reconnect a gas fitting. Note - All factory-made connections have been thoroughly checked for gas leaks.
PAGE 15
GAS INSTRUCTIONS Check: 1) Bulkhead fitting-to-Regulator connection. (1) WARNING: If there is a leak at connections (1), turn OFF the gas. DO NOT OPERATE THE FIREPLACE. Contact the Customer Service Representative in your area using the contact information on our web site. Log onto www.weber.com®. 2) 3) 4) Regulator-to-Quick disconnect fitting. Fitting-to-quick disconnect connection.
PAGE 16
OPERATING INSTRUCTIONS LIGHTING Summary lighting instructions are on the control panel. WARNING: Check hose before each use of fireplace for nicks, cracking, abrasions or cuts. If the hose is found to be damaged in any way, do not use the fireplace. Replace using only Weber® authorized replacement hose. Contact the Customer Service Representative in your area using the contact information on our web site. Log onto www.weber. com®. 1) 1. 6. 2. 4. 5. Remove rain shields.
PAGE 17
OPERATING INSTRUCTIONS 17 MANUAL LIGHTING 1) Remove rain shields. 1. DANGER Failure to remove rain shields while igniting the fireplace’s burners, or not waiting 5 minutes to allow the gas to clear if the fireplace does not light, may result in an explosive flame-up which can cause serious bodily injury or death. 2) 3) Make sure the burner control knob is turned OFF. (Push control knob down and turn clockwise to ensure that it is in the OFF position.) Turn the gas supply valve on. 4. 6. 2. 5.
PAGE 18
TROUBLESHOOTING PROBLEM CHECK CURE Burner burns with a dark orange flame, in conjunction with heavy sooting. Inspect Spider / Insect Screen for possible obstructions. (Blockage of holes.) Clean Spider / Insect Screen. (See Section “Annual Maintenance”) Burner does not light, or flame is low in HIGH position. Is fuel hose bent or kinked? Straighten fuel hose. Is igniter functioning properly? Replace igniter (see contact info. below).
PAGE 19
MAINTENANCE WEBER® SPIDER / INSECT SCREEN Your Weber® gas fireplace, as well as any outdoor gas appliance, is a target for spiders and other insects. They can nest in the venturi section (1) of the burner tube. This blocks the normal gas flow, and can cause the gas to flow back out of the air shutter. This could result in a fire, causing serious damage to your fireplace. Thus, it is imperative that control compartment, burners and air vents of the appliance be kept clean.
PAGE 20
MAINTENANCE MAIN BURNER FLAME PATTERN The Weber® gas fireplace burner has been factory set for the correct air and gas mixture. A correct flame pattern is: • A yellow to light-orange flame An incorrect flame pattern is: • A dark orange flame • Smoke-producing flame If the flames appear to be darker orange throughout the burner, sooting occurs, or smoke is produced; follow the burner and spider screen cleaning procedures.