Manual

ManualsBrandsweber ManualsGrills400

SUMMIT

400

LP Gas Barbecues

Step-By-Step Guide

WARNING: Do not try to light this appliance

without reading "Lighting" instructions

section of this manual.

THIS GAS APPLIANCE IS DESIGNED FOR

OUTDOOR USE ONLY.

NOTICE TO INSTALLER: These instructions

must be left with the owner and the owner

should keep them for future use.

FOR YOUR SAFETY

If you smell gas:

1. Shut off gas to the appliance.

2. Extinguish any open flame.

3. Open lid.

4. If odor continues, immediately call your

gas supplier or your fire department.

WARNING: Follow all leak check procedures

carefully in this manual prior to barbecue

operation. Do this even if barbecue was

dealer assembled.

FOR YOUR SAFETY

1. Do not store or use gasoline or other

flammable vapors and liquids in the

vicinity of this or any other appliance.

2. An LP tank not connected for use shall

not be stored in the vicinity of this or

any other appliance.

97462 10/97

A P P R O V E D

CANADIAN

GAS ASSOCIATION

National

Association

PROPANE

GAS

Summary of content (16 pages)

PAGE 1
SUMMIT 400 TM LP Gas Barbecues WEB E WEBE R Step-By-Step Guide R CANADIAN GAS ASSOCIATION ® National PROPANEGAS Association WARNING: Follow all leak check procedures carefully in this manual prior to barbecue operation. Do this even if barbecue was dealer assembled. NOTICE TO INSTALLER: These instructions must be left with the owner and the owner should keep them for future use. THIS GAS APPLIANCE IS DESIGNED FOR OUTDOOR USE ONLY.
PAGE 2
TOOLS NEEDED REMOVE PACKAGED CONTENTS 7/16 inch or open end or adjustable wrench Cooking grates (2) Flavorizer bars (7) SUPPLIES NEEDED Your LP tank is shipped empty for safety. After setting the LP fuel scale you will need to fill it. (See Step "Fill LP tank.") Cozy Heat Zone lid You will need a soap and water solution to check for gas leaks. (See Step "Check for gas leaks.") Note - The hardware size of nuts, bolts and screws is given.
PAGE 3
INSTALL FLAVORIZER BARS REINSTALL SPLASH GUARDS You will need: seven flavorizer bars. You will need: two splash guards Set the Flavorizer bars front to back over the burners in the slots of the Flavorizer Bar/cooking grill support. Figure 1(a). The splash guards are already in place. This step is only for reinstallation. Position splash guard, flanges to the rear, at the back of the cooking box assembly. Figure 2 (a). Insert both wire ends into the mounting holes in the cooking box. Figure 2 (b).
PAGE 4
REINSTALL SPLASH GUARDS (CONTINUED) ADD COOKING GRATES Splash guards open for use. Figure 3. The cross-rail of the cooking grate goes down. Set the cooking grates in place next to each other. Figure 5. You will need: two cooking grates. Figure 3 Figure 5 Splash guards closed for storage. Figure 4.
PAGE 5
INSTALL BOTTOM TRAY You will need: Bottom tray, catch pan holder, catch pan, and one drip pan. Mounting slots View from front of the Cooking Box Mounting slots Tabs of bottom tray Figure 6 Tabs of bottom tray Note: It may be easier to install the catch pan holder by removing the catch pan from the holder. Hook the ends of the catch pan holder into the hole in the bottom tray. Figure 7. Figure 9 Put the foil drip pan into the catch pan.
PAGE 6
ADD ACCESSORY RACK INSTALL TOOL HOLDERS You will need: accessory rack. You will need: four tool holders. Set the bottom rack between the two bottom connectors. Figure 10. Place the tool holder under the control panel and over the front panel. Figure 11 (a). Set the tool holder on top of the front panel and slide it to the left.
PAGE 7
SET LP FUEL SCALE FILL LP TANK You will need: LP tank (empty). To fill, take the LP tank and filler adapter to an RV center or look up gas-propane in the phone book for other sources of LP gas. Note - For accuracy, the fuel scale must be set with an empty tank. WARNING: We recommend that your LP tank be filled at an authorized LP gas dealer by a qualified attendant, who fills the tank by weight. We utilize various LP tank manufacturers.
PAGE 8
GENERAL TANK INFORMATION LP Tank Manufacturer The LP tank manufacturer is responsible for the materials, workmanship and performance of the tank. If the tank has a defect, malfunctions, or you have a question regarding the tank, call the tank manufacturer's customer service center. The phone number is on the warning decal which is permanently attached to the tank. If the tank manufacturer has not resolved the issue to your satisfaction, then call Weber-Stephen Products Co., Customer Service Center.
PAGE 9
CONNECT FILLED LP TANK (a) WARNING: Make sure that the LP tank valve is closed. Close by turning clockwise. Collar Hook the LP tank onto the fuel scale. Loosen the tank lock wing nut. Swing the tank lock down. Tighten the wing nut. Figure 14.
PAGE 10
CHECK FOR GAS LEAKS Put your fingers under the front edge of the control panel and lift up and pull evenly toward you. Figure 18 (a).  WARNING Front edge of the control panel The gas connections of your Weber Gas Barbecue have been factory tested. We do however recommend that you leak check all gas connections before operating your Weber Gas Barbecue. Remove control panel and front panel Take off all 4 burner control knobs. Pull up on the ignition buttons until they stay in the up position. Figure 16.
PAGE 11
CHECK FOR GAS LEAKS (CONTINUED) a)  DANGER b) Manifold Do not use an open flame to check for gas leaks. Be sure there are no sparks or open flames in the area while you check for leaks. This will result in a fire or explosion which can cause serious bodily injury or death and damage to property. WARNING: You should check for gas leaks every time you disconnect and reconnect a gas fitting.
PAGE 12
CHECK FOR GAS LEAKS (CONTINUED) REINSTALL FRONT PANEL You will need: control panel, front panel, and four burner control knobs. a) Hose to regulator connection. Figure 21 (a). With the Weber logo to the left, slide front panel down into place. Figure 22. b) Regulator to tank connection. Figure 21 (b). c) Hose to bracket connection. Figure 21 (c). WARNING: If there is a leak at connections 20 (a), 20 (b), 21 (a), or 21 (b), turn OFF the gas. Do not operate the barbecue. Contact your dealer.
PAGE 13
INSTALL CONTROL PANEL REINSTALL BURNER CONTROL KNOBS Pull igniter buttons up until they stay in the up position. Place the control panel into the grooves on either side of the front of the cooking box. Push the control panel into place, using even pressure while pushing. Figure 23 (a). Push on the burner control knobs. Figure 24. Use your fingers to lift the front edge of the control panel slightly and set it into the recess on both sides of the cooking box. Figure 23.
PAGE 14
EXPLODED VIEW FOR SUMMIT 400 LP 1 29 2 3 30 4 5 6 7 8-12 13 14 31 32 33 34 35 36 15 16 17 55 37 38 39-40 41 18 19 20 21 22 42 43 44 23 24 45-48 25 26 W 28 W E BE R E BE R 27 49 57 58 50 51 52 53 54 56
PAGE 15
REPLACEMENT PARTS LIST THE FOR SUMMIT 400 LP All items are single quantities unless otherwise specified. Parts can be ordered directly from Weber-Stephen Products Company by phone or mail. Note - Do not return parts to Weber-Stephen Products Co. without first contacting the Customer Service Center by phone or mail. Returning the part may not be necessary. While we give much attention to our products, unfortunately an occasional error may occur. If a part is missing, do not go back to the store.
PAGE 16