User manual

7
Check that the igniter is secure in the frame brace and
has not shifted out of the key hole. Figure 15.
If it is loose, slide the igniter into the rear of the key hole.
Carefully tighten the igniter lock nut with an adjustable
wrench or pliers.
Check that the tank panel tabs are in their slots in the
frame brace. Figure 16.
Check that all the burner valves are off.
Valves are shipped in the OFF position, but you should
check to be sure. Put the knob on each valve. Check by
pushing down and turning clockwise. If they do not turn,
they are off, proceed to the next step. Figure 17.
Figure 16
Figure 17
Tank panel tabs
Figure 15
Igniter lock nut
Keyhole in
frame brace
Small part of keyhole
in frame brace
Frame brace
Frame brace
(a)
(b)
(c)