Product Manual A

ManualsBrandsWeather Guard ManualsAutomotiveGull Wing Cross Box Extra-Wide Truck Tool Box — Steel, White, Rotary Latch, 71.5in. x 27.5in. x 18.5in.

ATTENTION: PLEASE READ AND UNDERSTAND ALL INSTRUCTIONS AND WARNINGS

BEFORE ASSEMBLING, INSTALLING OR USING THIS PRODUCT.

TRUCK STORAGE SOLUTIONS

SECURING YOUR REPUTATION

WEATHERGUARD.COM

INSTALLATION MANUAL

STEEL & ALUMINUM SIDE BOX WITH

PACK RAT

DRAWER UNITS

NOTICE

MODELS

DANGER

CAUTION

Use specic aluminum upt components when installing WEATHER GUARD® products to aluminum truck beds. Follow additional instructions if mounting to an

aluminum truck bed. There may be left over components depending on upt.

Any modication or unintended use of this product shall immediately void all manufacturers warranties. Manufacturer disclaims all liability for injuries to persons

or property resulting from any modication to, or unintended use of this product.

Danger of explosion. Do not use this product for storing or transporting ammables, explosives, hazardous materials, or hazardous waste, such as containers of

gasoline, solvents, gun powder, dynamite, propane tanks, acetylene tanks and cutting torches. This product is only intended and safe for use in storing and trans-

porting small tools, equipment and other similar materials. Any modications made to, or unintended use of this product, could create a hazardous condition that

can cause death, serious personal injury or property damage.

Part No. 24-0156 REV. E ECN 5583 05/15

Before marking the leg mounting holes, check inside the box for location of gas spring housing and components that may obstruct safe drilling. To keep debris out

of your eyes when checking the underside of the vehicle, or when drilling, always wear protective eyewear.

ALUMINUM & STEEL CROSS & SADDLE BOXES

Note: X represents the color code for your model: 0 = Clear | 3 = White | 5 = Black | 52 = Matte Black

114-X-01, 115-X-01, 120-X-01, 121-X-01, 123-X-01, 124-X-01, 125-X-01, 131-X-01, 136-X-01, 137-X-01,

154-X-01, 156-X-01

SADDLE

BOX

CROSS

BOX

Summary of content (5 pages)

PAGE 1
INSTALLATION MANUAL TRUCK STORAGE SOLUTIONS SECURING YOUR REPUTATION ® STEEL & ALUMINUM SIDE BOX WITH ALUMINUM & STEEL CROSS & SADDLE BOXES ® PACK RAT DRAWER UNITS ATTENTION: PLEASE READ AND UNDERSTAND ALL INSTRUCTIONS AND WARNINGS BEFORE ASSEMBLING, INSTALLING OR USING THIS PRODUCT.
PAGE 2
TOOLS REQUIRED • 1/2" Ratchet Wrench • Ruler PARTS LIST Note: The rubber mounting pad comes as a single piece and must be separated into two pieces, one for each side of the truck.
PAGE 3
STEP 2 Attach Box to Truck Bed Note: • Mounting clamp bolt may be difficult to turn due to the “lock nut” feature. Apply a small amount of grease to bolt threads prior to installation to ease assembly. Attach mounting clamp, bolts and washers as shown in figure to the right. Start with slot at drivers side front and work clock-wise until all four clamps have been installed.
PAGE 4
WARNING Extension Cord Cordless Power Tool Battery Chargers • Follow all Extension Cord manufacturer’s warnings and instructions. • DO NOT insert extension cord through hole without grommet in place. • Only use a three-wire extension cord with all three prongs intact. Never remove the round grounding prong. • Extension cord must be connected to a 120 Volt GFCI protected outlet with proper ground. If GFCI outlet is not available, use an extension cord with GFCI protection built in.
PAGE 5
KNAACK LLC LIMITED LIFETIME WARRANTY FOR WEATHER GUARD® PRODUCTS WEATHER GUARD® Products — Limited Lifetime Warranty (Purchased on or after 1/1/2009) KNAACK LLC (the “Manufacturer”) warrants to the original purchaser only that WEATHER GUARD® Truck and Van Products (the “WEATHER GUARD® Product”) will be free from defects in material and workmanship from the date of purchase and continuing for the expected lifetime of the WEATHER GUARD® Product.