SDS

ManualsBrandsWD-40 ManualsAutomotiveSpecialist® Dirt & Dust Resistant Dry Lubricant - 10 oz.

Page 1 of 5

Safety Data Sheet

1 - Identification

Trade Name: WD-40 Specialist

Dirt & Dust

Resistant Dry Lube

Chemical Name: Organic Mixture

Product Use: Cleaner, Lubricant

Restrictions on Use: None identified

SDS Date Of Preparation: 07/13/14

Manufacturer: WD-40 Company

Address: 1061 Cudahy Place (92110)

P.O. Box 80607

San Diego, California, USA

92138 –0607

Telephone:

Emergency only: 1-888-324-7596 (PROSAR)

Information: 1-888-324-7596

Chemical Spills: 1-800-424-9300 (Chemtrec)

1-703-527-3887 (International Calls)

2 – Hazards Identification

Hazcom 2012/GHS Classification:

Flammable Aerosol Category 1

Gas Under Pressure: Compressed Gas

Aspiration Toxicity Category 1

Skin Irritant Category 2

Specific Target Organ Toxicity Single Exposure Category 3 (nervous system effects)

Note: This product is a consumer product and is labeled in accordance with the US Consumer Product

Safety Commission regulations which take precedence over OSHA Hazard Communication labeling. The

actual container label will not include the label elements below. The labeling below applies to

industrial/professional products.

Label Elements:

DANGER!

Extremely Flammable Aerosol.

Contains gas under pressure; may explode if heated.

May be fatal if swallowed and enters airways.

Causes skin irritation.

May cause drowsiness or dizziness.

Prevention

Keep away from heat, sparks, open flames, hot surfaces – No smoking.

Do not spray on an open flame or other ignition source.

Pressurized container: Do not pierce or burn, even after use.

Avoid breathing vapors or mists.

Wash thoroughly with soap and water after handling.

Use only outdoors or in a well-ventilated area.

Wear protective gloves.

Response

IF SWALLOWED: Immediately call a POISON CENTER or physician. Do NOT induce vomiting.

IF ON SKIN: Wash with plenty of soap and water. If skin irritation occurs: Get medical attention. Take off

contaminated clothing and wash before reuse.

Summary of content (5 pages)

PAGE 1
Safety Data Sheet 1 - Identification Manufacturer: WD-40 Company Address: 1061 Cudahy Place (92110) P.O.
PAGE 2
IF INHALED: Remove to fresh air and keep at rest in a position comfortable for breathing. Call a POISON CENTER or physician if you feel unwell. Storage Store locked up. Protect from sunlight. Do not expose to temperatures exceeding 50°C/122°F. Store in a well-ventilated place. Disposal Dispose of contents and container in accordance with local and national regulations.
PAGE 3
6 – Accidental Release Measures Personal Precautions, Protective Equipment and Emergency Procedures: Wear appropriate protective clothing (see Section 8). Eliminate all sources of ignition and ventilate area. Methods and Materials for Containment/Cleanup: Leaking cans should be placed in a plastic bag or open pail until the pressure has dissipated. Contain and collect liquid with an inert absorbent and place in a container for disposal. Clean spill area thoroughly. Report spills to authorities as required.
PAGE 4
Odor Threshold: pH: Melting/Freezing Point Boiling Point/Range: Not established Not Applicable Not established 90-140°C (194-284°F) Flash Point: Evaporation Rate: <-29.2°F Tag Closed Cup Not established Flammability (solid, gas) VOC: Flammable Aerosol 93.2% Vapor Density: Relative Density: Solubilities: Partition Coefficient; noctanol/water: Autoignition Temperature: Decomposition Temperature: Viscosity: Pour Point: Greater than 1 (air=1) 0.
PAGE 5
If this product becomes a waste, it would be expected to meet the criteria of a RCRA ignitable hazardous waste (D001). However, it is the responsibility of the generator to determine at the time of disposal the proper classification and method of disposal. Do not puncture or incinerate containers, even empty. Dispose in accordance with federal, state, and local regulations. 14 – Transportation Information_ DOT Surface Shipping Description: UN1950, Aerosols, 2.1 Ltd.