Instructions / Assembly

Watch and Assemble www.waybasics.com/help-door-cube Help and Comments www.waybasics.com/contact Share and Win www.waybasics.com/share
1 2 3
4 5 6
(Press)
Carefully remove the 3M
protective layer from adhesive.
Place alignment pins in vertical
zBoards.
First fit backer board in groove, then
arrange vertical zBoard with grooves
facing backer board as shown.
Align top zBoard. Orient door properly as shown and
align bottom pin. Press on spring
loaded top pin and insert.
Join other connect cubes with
connector pins! Visit links below for
more details. Enjoy building possibilities!
Note Use included decals to cover the
connector holes if not stacking cubes.
CONNECT DOOR CUBE
Important
Tip Start assembly from bottom to top.
DO NOT place unit on its side or back as
it will compromise its structural integrity.
THIS SIDE UP
WARNING: CHOKING HAZARD
Small parts NOT for children under 3 years
1 Bottom zBoard
with door pin slot
1 Top zBoard
with magnetic door stopper
2 Vertical zBoards
adhesive strips on 2 edges
8 Alignment Pins
4 connectors pins
1 Backer Board
thin and has no adhesive
1 zBoard Door
Included
• Assemble your unit on a flat even surface, carpet not recommended
• Furniture is for indoor use only
• When moving your Way Basics furniture, lift from the bottom
• Make sure zBoard surfaces are clean and dry