User's Manual
Table Of Contents
- Introduction
- The Integrator’s Task
- Installing the Modem
- Mounting the Boomer˚III OEM Modem to Your Device
- Connecting the Data Interface Port
- Selecting & Positioning the Antenna
- Supplying Power
- Using the Modem Test Jig
- Software Development Tools
- Integration Testing
- Appendix A – Guide to Desense
- Appendix B - Numeric Conversion Chart
- Appendix C – Boomer-III Specifications
- Appendix I - Glossary
Installation________________________________________________ Boomer-III User Manual & Integrator’s Guide
Copyright Wavenet Technology © October 2003 34 BM310012WT05
LED Indicators
The modem provides three on-board indicators (LED’s), for diagnostic
monitoring purposes as well as three modem controllable LED outputs
through the Data Interface Connector.
On-Board LED Indicators
The on-board LED’s are visible through windows in the case of the
modem and are defined as below.
Position of On-Board LED Indicators
On-Board LED Indicator Definitions
Operating Mode
LED Indicator Colour
Off On Flashing
POWER Green Power off
Power normal and
locked on channel
Power normal and
scanning channels
TRANSMIT DATA Red No activity N/a Data Transmitted
RECEIVE DATA Green No activity N/a Data Received
Note: The LED’s may be disabled to minimise power consumption. All
LED’s will flash on start-up and the Receive and Transmit LED’s will
flash on power down regardless of the state of the LED disable control.
Power
Receive
Transmit