User's Manual
Table Of Contents
- Introduction
- The Integrator’s Task
- Installing the Modem
- Mounting the Boomer˚III OEM Modem to Your Device
- Connecting the Data Interface Port
- Selecting & Positioning the Antenna
- Supplying Power
- Using the Modem Test Jig
- Software Development Tools
- Integration Testing
- Appendix A – Guide to Desense
- Appendix B - Numeric Conversion Chart
- Appendix C – Boomer-III Specifications
- Appendix I - Glossary
Boomer-III User Manual & Integrator’s Guide____________________________________________ Integrator’s Task
BM310012WT05 21 Copyright Wavenet Technology © October 2003
ensure compliance, operations at closer than this distance is not
recommended."
If an antenna system is used which has an average gain greater than
5dBi then the integrated product must be re-tested as a complete unit
and submitted with its own FCC ID.
It is mandatory for portable integrated products such as handheld and
body-worn devices to comply with FCC guidelines for Specific
Absorption Rate (SAR) requirements. Refer to OET Bulletin 65 and
Supplement C (June 2002). The submission should include end product
information, end product SAR/MPE test report, and a reference to the
Wavenet Boomer-III OEM Modem Module FCC ID for all other
Part 90 requirements.
It is a requirement for integrated product certification that you provide
the following statement in user documentation:
“Regulatory Notice of Compliance
This equipment has been tested and found to comply within the
limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation.
This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and
receiver.
Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV
technician for help.”
Labelling
The FCC requires the integrated product to be labelled as shown here:
“This product contains a type-accepted transmitter approved
under FCC ID: PQS-BM3900M.”
Refer to FCC CFR 47, Part 2, Subpart J for information on obtaining
an FCC grantee code, FCC identifier requirements, label requirements,
and other equipment authorisation procedures.