Submittal Sheet

AquaLock
™
Plastic
Elbows
Watts AquaLock push-to-connect Elbows are designed and
manufactured for many years of trouble free service. Produced
of off white Polysulfone, a high performance thermal plastic
material, the Watts AquaLock design allows for quick and easy
connections without the use of installation tools.
Specifications
Connection shall be made using Watts AquaLock Plastic fitting
with Integral Collet and O-Ring guide. Fitting shall be able to fully
rotate under pressure and allow for easy disconnect and reuse
without the use of disconnection tools. Fitting must not disas-
semble to disconnect.
Approvals
NSF-61, NSF-14, CSA B137.5, ASTM F877, UPC, ASSE 1061
Ratings
100psi @ 180°F (6.8 bar @ 82°C)
250psi @ 75°F (17.3 bar @ 24°C)
Example
3512-1008
35 = Plastic
12 = Hose Barb Elbow
1008 =
1
⁄2" CTS x
1
⁄2" Barb
ES-AQ-35Elbows
Job Name
–––––––––––––––––––––––––––––––––––––––––––
Contractor
––––––––––––––––––––––––––––––––––––––––––––
Job Location
–––––––––––––––––––––––––––––––––––––––––
Approval
–––––––––––––––––––––––––––––––––––––––––––––
Engineer
–––––––––––––––––––––––––––––––––––––––––––––
Contractor’s P.O. No.
––––––––––––––––––––––––––––––––––
Approval
–––––––––––––––––––––––––––––––––––––––––––––
Representative
––––––––––––––––––––––––––––––––––––––––
3512
3517
3518
3521
3519
3520
LEAD FREE
*
Watts product specifications in U.S. customary units and metric are approximate and are provided for reference only. For precise measurements,
please contact Watts Technical Service. Watts reserves the right to change or modify product design, construction, specifications, or materials with-
out prior notice and without incurring any obligation to make such changes and modifications on Watts products previously or subsequently sold.
The information contained herein is not intended to replace the
full product installation and safety information available or the
experience of a trained product installer. You are required to
thoroughly read all installation instructions and product safety
information before beginning the installation of this product.
NOTICE
*The wetted surface of this product contacted by consumable
water contains less than 0.25% of lead by weight.
CAUTION
!
The polysulfone material used in the AquaLock
™
fittings can
be compromised by exposure to volatile organic compounds
(VOC’s) and caustic chemicals. Therefore, DO NOT expose this
product to any such chemical or foreign substance, which would
include exposure to the following products: Pipe Dopes (thread
sealants), bug sprays, lubricants, cleaners, paints, bleaches,
acids, solder fluxes, plastic piping primers and cements, oxidizing
agents, alkaline solutions, thinners, fuels, oil based caulks, hydro-
carbons, spray foam of foaming agents (insulation).
It is also recommended that all threaded connections be made
with Teflon
®
tape only.