Installation guide

WATERS NETWORK SYSTEMS™ ProSwitch
®
- 2600M, User’s Manual, 02/07 Page 44
6.15 QoS Settings
The 2600M switch supports four priority queues on each port for QoS operation.
Use the following steps to configure the QoS function:
1. Select Enable in the QoS Function section of the screen.
2. Click Apply to enable the function.
3. If you are using port-based priority, select the ports for High and Low priorities in the
Port Priority section of the screen. The packets from high priority port will be
forwarded to the highest priority queue on egress port. The packets from low priority
port will be forwarded to the lowest priority queue on egress port.
4. Select the ports that enable the 802.1P priority function. Packets will be forwarded
with the priority information in tag. Configure the 802.1P priority mapping to priority
queue of port. The priority value is 0 ~ 7 for the 802.1P tagged packets.
5. Click Apply to activate the settings.
To disable the QoS operation, select Disable and click Apply.
6.18 – QoS Settings