Troubleshooting guide

Time of day should only need to be set after extended power outages or when daylight saving time begins or ends. If an

extended power outage occurs, the time of day will flash on and off indicating that the time should be reset.

STEP 1 – Press set clock.

STEP 2 – CURRENT TIME (HOUR): Set the hour of the day using + or — buttons. AM/PM toggles after 12.

Press next to go to step 3.

STEP 3 – CURRENT TIME (MINUTES): Set the minutes using + or — buttons. If it is desired to back up to

the previous step press regen button once. Pressing next will exit set clock and return to the general

operating display (page 10).

1. Set time of day:

NOTE: The manufacturer has preset the unit so that the gallons between regenerations will

be automatically calculated after the hardness is entered.

STEP 1 – Press next and + simultaneously for 3 seconds.

STEP 2 – HARDNESS: This display will show “–nA– (not available)” if “FILTER”

is selected.

Press next to go to step 3. Press regen to exit.

STEP 3 – DAY OVERRIDE: The manufacturer has factory set 3 DAYS as the

default. This is the maximum number of days between regenerations.

If this is set to “OFF”, regeneration initiation is based solely on

gallons used. If any number is set (allowable range from 1 to 28), a

regeneration initiation will be called for on that day even if a sufficient

number of gallons were not used to call for a regeneration.

Set Day Override using + or — buttons (3 is recommended):

• set number of days between regeneration (1 to 28); or

• set to “OFF”.

Press next to go to step 4. Press regen if you need to return to the

previous step.

STEP 4 – REGENERATION HOUR: The manufacturer has factory set 12:00 A.M.

as the default. This is the hour of day for regeneration and can be reset

by using + or — buttons. “AM/PM” toggles after 12. The default time is

12:00 a.m. (recommended for a normal household).

Press next to go to step 5. Press regen if you need to return to the

previous step.

STEP 5 – REGENERATION MINUTES: Set the minutes using + or — buttons.

Press next to exit installer programming. Press regen if you need

to return to the previous step. To initiate an immediate manual

regeneration, press and hold the regen button for three seconds.

The system will begin to regenerate immediately. The control may be

manually stepped through the regeneration cycles by pressing regen.

STEP 6 – BACKLIGHT DISPLAY CONTROL (Not available on all models):

Set the display backlight on or off using + or — buttons. In the OFF

position, the backlight will turn off after 5 minutes of inactivity.

2. Programming:

PROGRAMMING PROCEDURES: