Specification
TECHNICAL DATA
WAT-15
WATCO
®
DANISH OIL FINISH (275 VOC)
Form: GDH-882
Rev.: 063015
1
.DESCRIPTION AND USES .
Watco
®
Danish Oil Finish is a unique blend of penetrating oil &
varnish that stains, seals and protects in one easy step. Danish
Oil penetrates deep into wood pores to protect from within and to
enhance the natural look of the wood. It creates the rich, warm
glow of a traditional hand-rubbed finish. Danish Oil will not chip,
peel or wear away. Danish Oil is recommended for furniture, trim,
molding or any bare wood interior surface. It is not
recommended for floors or exterior surfaces. Danish Oil is easy
to use. Simply brush or wipe on and wipe off.
. FEATURES .
Stains, seals & protects
Penetrates deeply
Easy, wipe-on application
.PRODUCTS .
SKU Description
242217 Natural 1-Gallon
242222 Medium Walnut 1-Gallon
265500 Dark Walnut 1-Pint
265502 Natural 1-Pint
265504 Medium Walnut 1-Pint
265507 Cherry 1-Pint
242211H Golden Oak 1-Pint
242731H Fruitwood 1-Pint
PRODUCT APPLICATION .
SURFACE PREPARATION
Ensure the wood is dry and that all previous coatings such as
paint or varnish are completely removed. Sand wood smooth
and wipe clean.
WARNING! If you scrape, sand or remove old paint, you may
Release lead dust. LEAD IS TOXIC. EXPOSURE TO LEAD
DUST CAN CAUSE SERIOUS ILLNESS SUCH AS BRAIN
DAMAGE, ESPECIALLY IN CHILDREN. PREGNANT WOMEN
SHOULD ALSO AVOID EXPOSURE. Wear a NIOSH-approved
respirator to control lead exposure. Clean up carefully with a
HEPA vacuum and a wet mop. Before you start, find out how to
protect yourself and your family by contacting the National Lead
Information Hotline at 1-800-424-LEAD or log on to
www.epa.gov/lead.
.
PRODUCT APPLICATION (cont.) .
APPLICATION
Shake container thoroughly and test for color on a hidden section
of wood. NOTE: To ensure uniform color and/or appearance,
complete the entire project with the same stain color as shown
on the label. Flood the surface with a brush or cloth, applying
additional finish to areas that absorb all of the liquid. Allow to
penetrate for 30 minutes. Re-apply allowing an additional 15
minutes penetration. Wipe the surface completely dry. The
surface is ready for use in 8-10 hours.
If a topcoat such as a polyurethane is desired, allow Watco
Danish Oil to dry 72 hours before application of the polyurethane.
MAINTENANCE
Apply fresh coats as needed to repair surface scratches and
remove minor stains. Burnish affected area with fine steel wool or
220 grit sandpaper. Then apply the color of Watco Danish Oil
originally used to finish the wood.
CLEAN UP
Clean application tools and equipment with mineral spirits or
paint thinner.
OPTIONAL STEPS
Pre-treat soft woods such as pine by lightly wiping the wood
surface with a cloth dampened with Danish Oil Finish in Natural.
Immediately wipe the surface completely dry and apply the
Danish Oil Finish in your color of choice. If a clear wood finish
such as polyurethane is desired, use Varathane Interior Premium
Polyurethane or Varathane Professional Polyurethane.
NOTE: Dry time varies with temperature, humidity and ventilation.