Owner's Manual
Table Of Contents
- Headphones Quick Start Guide
- M1 Amplifier Quick Start Guide
- The Electrostatic Headphone System User Manual
- REVISION HISTORY
- TRANSLATED WARNING AND CAUTION MESSAGES
- BEFORE OPERATION PLEASE READ THESE INSTRUCTIONS
- REGULATORY COMPLIANCE STATEMENTS
- CHAPTER 1 INTRODUCTION
- CHAPTER 2 INSTALLATION
- SYSTEM CONTENTS
- FRONT PANEL CONTROLS
- REAR PANEL CONNECTIONS/CONTROLS
- HEADBAND ADJUSTMENT
- POSITIONING THE HEADPHONES
- CONNECTING THE HEADPHONE CABLE
- DETACHING THE HEADPHONE CABLE
- CONNECTING THE HEADPHONES TO THE AMPLIFIER
- CONNECTING ANALOG AND DIGITAL SOURCES TO THE AMPLIFIER
- ASSEMBLING AND CONNECTING THE POWER SUPPLY UNIT
- POWERING THE UNIT ON
- CHAPTER 3 OPERATION
- CHAPTER 4 COMPUTER-BASED AUDIO SET-UP
- CHAPTER 5 CARE AND MAINTENANCE
- CHAPTER 6 TROUBLESHOOTING
- CHAPTER 7 CUSTOMER SERVICE
- GLOSSARY
- WARRANTY
COMPUTER-BASED AUDIO SET-UP
14
Press the SEARCH button to instruct the application to locate the
Sonoma Model One that is plugged into the USB port.
Upon finding the unit, the application will show the current firmware
version at the top of the dialog.
To update this version to a newer (or older) firmware version, press
the FW FILE button then locate and select the replacement firmware
file. It will have a .bin suffix. For example: Sonoma_Model_One_V1-1-
0.bin.
The correct firmware file will be shown in the dialog window.
Confirm that you have selected the correct file and press the UPDATE
DEVICE button. During the update, you will see the progress bar
advance, and messages will appear at the bottom of the dialog window.