Half Gallon Hi-Power Blender MX1000R INSTRUCTION BOOKLET
IMPORTANT UNPACKING INSTRUCTIONS 1. Place the box containing your Waring Pro® blender on a flat sturdy surface before unpacking. 2. Open corrugated flaps. 3. Remove instruction book and any printed materials from top of box. 4. Pull up corrugation and remove. Remove jar and padding. CAUTION: Sharp blade inside blender jar. 5. Remove corrugated insert. Remove blender base from box and set aside. 6. Replace all corrugated inserts in the gift box and save the box for repacking. REPACKING INSTRUCTIONS 1.
8. Do not use outdoors. 9. Do not let cord hang over edge of table or counter, or touch hot surfaces. 10. Keep hands and utensils out of container while blending, to prevent the possibility of severe personal injury and/or damage to the blender. A rubber scraper may be used, but must be used only when the blender is not running. 11. Blades are sharp. Handle carefully. 12. Always operate blender with lid in place. 13. When blending hot liquids, remove center piece of two-piece lid.
GROUNDING INSTRUCTIONS • For your protection, this appliance is equipped with a 3-conductor cord set. • 120 Volt units are supplied with a molded 3-prong grounding-type plug (NEMA 5-15P) and should be used in combination with a properly connected grounding type outlet as shown in Figure A. If a grounding type outlet is not available, an adapter, shown in Figure B, may be utilized to enable a 2-slot wall outlet to be used with a 3-prong plug (except in Canada and Europe).
7. Allow motor to come to a complete stop before removing container from blender base. Never place the container on the motor base or remove it from the motor base while motor is running. 8. Always hold container with one hand when starting and while blending. Never operate without jar lid. 9. Wash and dry container after each use. See Cleaning and Sanitizing instructions.
• In repetitive batch-processing applications, frequent cleaning of the container will prolong the life of the blade assembly. In no case should actual running time between cleanings exceed 1/2 hour. • Do not use container to store processed foods or beverages. To wash and rinse container: 1. REMOVE CONTAINER FROM MOTOR BASE. Remove lid. Rinse container interior and lid under running water. Add washing solution to container.
NOTES ___________________________________________________________ ___________________________________________________________ ___________________________________________________________ ___________________________________________________________ ___________________________________________________________ ___________________________________________________________ ___________________________________________________________ ___________________________________________________________ __________________________
©2010 Waring Consumer Products 150 Milford Road East Windsor, NJ 08520 www.waringpro.com Any other trademarks or service marks of third parties referred to herein are the trademarks or service marks of their respective owners.
