Use and Care Manual

To ensure proper operation and equipment life, please follow the instructions
below for assembly, cleaning and maintenance. Be sure to clean batter dispenser
thoroughly before first use and after each use. Daily cleaning is recommended.
ASSEMBLY & INSTRUCTIONS
1. Remove the batter dispenser from the packaging.
2. Rinse and dry batter container, spigot, saucer and lid before using. Wash using
a mild soap and water solution with sponge. Run clean water through the spigot.
3. Place batter dispenser on a sturdy, level surface, away from the edges of
the countertop.
4. Be sure that the spigot is secure on the batter container by tightening the
collar clockwise.
5. Pour mixed batter into the batter container.
6. Place the batter container onto the dispenser base with the spigot facing
outward. The indents on the bottom of the container should align with the
bump-outs on the top of the base.
7. Place the lid onto the top of the dispenser housing and place the saucer on the
housing underneath the spigot.
8. To dispense batter, place a batter cup underneath the spigot and push the
spigot lever back.
NOTE: When full, batter dispenses at a quick rate. When batter is low,
the batter will dispense slowly. Refill with batter as needed to keep the
flow rate quick.
WBD2G Series – 2-Gallon
Batter Dispenser Instructions