Installation Guide

1
Introduction
Congratulations! You have acquired your very
own piece from the Wallscapes collection. This
means that you are about to enhance your
walls with hardwoods that are full of character.
Your eye for design will inspire for years to
come.
Our wall panels have been thoughtfully crafted
and designed for all types of interiors. The
manual will guide you through the installation
process in five simple steps.
Two golden rules
The two golden rules for the best result are:
1 Paint your receiving wall black prior to
installation.
2 Place the wall panels in a random bond.
You will find these golden rules clearly
marked in bold writing later in this
installation manual.
Owner / installer responsibility
All of our panels are thoroughly inspected to
ensure that you receive only the very finest
specimen hardwoods nature has to bestow. As
all of our materials are natural however some
natural variations in grading may occur. It is the
installer’s responsibility to check the suitability
of all panels prior to installation. In the highly
unlikely event that any defects are found to be
present, you should contact your supplier
immediately. Do not install panels you suspect
to be defective as we cannot ac-cept returns
once panels have been installed.
It is the installer’s responsibility to ensure that
the project site is suitable and that the panels
are correctly installed (see later). The
manufacturer accepts no responsibility for
failure due to incorrect or inappropriate
installation.
Project site – Inspection
The Wallscapes collection is suitable solely for
3D Wall or installation. The project site should
be fully enclosed to the elements and all
receiving walls should be completely dry.
The receiving wall
Our wall paneling may be applied to a range of
receiving surfaces. For the best results we
recommend fixing to an even surface. Flat walls
are ideal but by no means vital; a small degree
of unevenness is acceptable and will not cause
problems.
Condition of receiving wall - general
In general, surfaces should be clean and free
from any loose material or debris. They should
be completely dry and structurally capable of
supporting the aggregate panel weight,
together with that of any backing strata
(where used).
For the best result it is recommended to paint
the receiving wall black before mounting.
Tool Check list and accessories needed
Tools you will need for the job.
All installations
Broom and/or vacuum, spirit level and/or
cross laser level, handsaw, table saw and/or
crosscut saw, tape measure, pencil, utility
knife, extension cord, ladder and personal
protective equipment.
For mounting with adhesive
Silicon gun and elastic MS polymer High Tech.
For mounting with tacker
Tacker, brads 1/20" thickness and 1.2" - 2"
depending on the wall panelling type being
installed
EN
External corner solutions
wood vertical
If a vertically placed corner solution is prefer
red we recommend one row of the wall panel
overlap so the side of one for the panels is
visible.
Internal corner solutions wood vertical
In case of an internal corner a seamless
unbroken row of vertical panels is achieved by
joining corresponding panels using a mitered
edge. Connect the return wall using the other
half piece from the joining panel.
Disclaimer
Our panels are made entirely of authentic,
reclaimed hardwoods from a variety of
sources. Wood is a natural material that
contains distinctive characteristics in grain
colour and texture. Photographs and physical
samples should be viewed as illustrative of the
collection they represent;in no way should
they be regarded as being definitive or of
guaranteeing an exact match. Each individual
panel is unique. Please note that no returns
are offered for product that has been installed.
With this in mind we always advise that you
take the opportunity to experiment with
different panel arrangements prior to final
installation.
Your statutory rights are not affected.
LTL Home Products, Inc
[phone]
ltlhomeproducts.com