Quick Start Guide

-12-
Take
off
Landing
GPS
Manual
Take
off
Landing
GPS
Manual
Manual
Manual
Take
off
Landing
GPS
Take
off
Landing
GPS
Manual
Take
off
Landing
GPS
Manual
Take
off
Landing
GPS
12.0 Operation Instruction
2) When the status indication on the top of Walkera Drone App is shown as “Connected”,
the you can use the App to control the aircraft.
1) Make sure that the received GPS signal (Blue LED light blinks)
AUTO Takeoff (remote controller or APP operation)
Please unlock the motor before take off. (Unlocking method, please refer to 11)
Attention:
AUTO takeoff default height is 3m, when it need to manual control the throttle,
the throttle stick must be pushed to the midpoint or more, that it can remove AUTO takeoff mode.
Please click the icon in the APP
main interface, then the aircraft
will take off automatically.
Switch to “Take off”
position
Short press the Enter key,
aircraft will take off
automatically.
AUTO Landing (remote controller operation)
Ground
3m
Ground
Ground
Switch to “Landing”
position
Short press the Enter key,
aircraft will land
automatically.
1) When you used the function of “AUTO landing”, the landing gear of aircraft will be extended.
2) During the landing, you can operate the aircraft be forward and backward or right and left.
Attention:
GPS hold mode (Remote controller operation)
Switch to “GPS”
position
Short press the Enter key to
enter the GPS hold mode
Throttle stick
return neutral
Attention:
1) The first flight default to GPS Mode after each power on.
2) In the GPS mode, there are Altitude hold, fixed point, brake function, the flight speed is slower (≤5m/s).
3) If the GPS signal is poor or no signal, can only be Altitude hold, but not fixed point.
4) Switch to manual mode can not be fixed point.
Quick Start Guide