BR3DNS Assembly Instructions Keep these instructions for future reference. Revised 03/2018 P.
P.
1 7 12 14 6 13 2 10 11 3 3x 5 9 4 8 8 9 1 Top panel 01 pcs 8 Right foot 02 pcs 2 Right side panel 01 pcs 9 Left foot 02 pcs 3 Left side panel 01 pcs 10 Front drawer 03 pcs 4 Bottom front crossbeam 01 pcs 11 Left side drawer 03 pcs 5 Back crossbeam 01 pcs 12 Right side drawer 03 pcs 6 Upper front crossbeam 01 pcs 13 Drawer bottom 03 pcs 7 Back panel 02 pcs 14 Drawer back 03 pcs P.
A Ø8*30mm Wooden dowel 28 pcs B Ø3,0*14mm Screw 18 pcs C Ø6,0*10mm Screw 12 pcs D Ø4,0*30mm Screw 37 pcs E M4*22mm Screw 03 pcs F Ø4,5*45mm Screw 12 pcs G Ø10*10 Nail 16 pcs H 300mm Right Slide 03 pcs I 300mm Left Slide 03 pcs J Knob 03 pcs K Glue 01 pcs Hammer recommended for assembly (not included) P.
Step 1 Please assemble on a clean soft surface to avoid damage. A A A A 2 A A 3 A AA 12 6 3x A AA AA 11 3x AA 4 AA 5 A AA K 01 Glue tube A 28 Ø8*30mm Step 2 Please assemble on a clean soft surface to avoid damage. C C Pre-Drilled holes C C C C C C C C 3 C C I H I H I 2 H C C C 12 Ø6,0*10mm I The wheel to the Front H 03 Right slide 300mm I H The wheel to the Front 03 Left slide 300mm P.
Step 3 3 6 4 D 2 D D D 5 K 01 Glue tube D 04 Ø4,0*30mm Step 4 1 D D D D K 01 Glue tube D 06 Ø4,0*30mm P.
Step 5 D D D D D 03 Ø4,0*30mm Step 6 9 F F F F 8 8 F F F F Apply glue to leg contact surfaces 1º 9 F 2º K F F F 12 Ø4,5*45mm K 01 Glue tube P.
Step 7 G G G G G G G 7 G G G G G G G G 16 Ø10*10 Step 8 14 12 D 11 D D D DD D 13 D 10 3x The wheel to the Back 3x B B B Bottom E I B J B 3x H 3x B E 03 M4x22mm B 12 Ø3,0*14mm D 24 Ø4,0*30mm I 03 Left slide 300mm H 03 J 03 Right slide 300mm P.
Step 9 To adjust the drawer front position: Loosen the screw (part C) you used to install the drawer runner (either parts H or I) in step 2, to the side panel (parts 02 or 03), depending on the side (left or right), as shown. With the screw (part C) loosened, you can make the necessary slight adjustments (up or down) to the drawer runner to achieve the proper drawer alignment.