71012402/WPMDH1152401J MagI³C Power Module Product Family VDRM - Variable Step Down Regulator Module DESCRIPTION The VDRM series of the MagI³C Power Modules Family comprise a fully integrated current mode DC/DC power supply with both the switching power stage, control circuitry and passive all in one package These devices also feature built-in compensation circuitry and a soft-start feature for a smooth, safe power up.
171012402/WPMDH1152401J MagI³C Power Module Product Family VDRM - Variable Step Down Regulator Module A PACKAGE MARKING First row: Logo & Date code XYTTES WPMXX 1234567XX 3 4 5 6 7 VOUT 2 Third row: Parameter code FB 1 Second row: Product family and type 6 SS EN AGND VIN RON 7 Top View 7 PIN PFM B PIN DESCRIPTION PIN # PIN SYMBOL 1 2 3 4 5 6 7 EP VIN RON EN AGND SS FB VOUT EP C PIN DESCRIPTION Input power supply Set the frequency of the application Remote ON/OFF Reference grou
171012402/WPMDH1152401J MagI³C Power Module Product Family VDRM - Variable Step Down Regulator Module E ABSOLUTE MAXIMUM RATINGS (1) Preventive Caution: Exceeding the listed absolute maximum ratings below may affect the device negatively and may cause permanent damage. Therefore operating ratings are conditions under which operation of the device is intended to be functional. All values are referenced to GND and to a free ambient operating temperature of TA=25 ± 5°C unless otherwise specified.
171012402/WPMDH1152401J MagI³C Power Module Product Family VDRM - Variable Step Down Regulator Module H ELECTRICAL SPECIFICATIONS Limits are valid for recommended junction temperature range of -40°C to 125°C. Typical values represent the most likely norm at following conditions: VIN=24V, VOUT=12V, RON=249kΩ, TA=25°C, unless otherwise specified.
171012402/WPMDH1152401J MagI³C Power Module Product Family VDRM - Variable Step Down Regulator Module I TYPICAL PERFORMANCE CURVES If not otherwise specified, the following conditions apply: VIN = 24V; CIN = 10µF X7R Ceramic; CO = 47µF, TAMB = 25°C Power Loss: VOUT = 5V @ TAMB = 25°C 100 3.0 95 2.5 Power Loss [W] Efficiency [%] Efficiency: VOUT = 5V @ TAMB = 25°C 90 85 80 VIN = 8V VIN = 12V VIN = 24V 75 2.0 1.5 1.0 0.5 70 0.0 0.0 0.5 1.0 1.5 0.0 Output Current [A] 95 2.
171012402/WPMDH1152401J MagI³C Power Module Product Family VDRM - Variable Step Down Regulator Module I TYPICAL PERFORMANCE CURVES If not otherwise specified, the following conditions apply: VIN = 24V; CIN = 10µF X7R Ceramic; CO = 47µF, TAMB = 25°C Power Loss: VOUT = 5V @ TAMB = 85°C 100 3.0 95 2.5 Power Loss [W] Efficiency [%] Efficiency: VOUT = 5V @ TAMB = 85°C 90 85 80 VIN = 8V VIN = 12V VIN = 24V 75 VIN = 8V VIN = 12V VIN = 24V 2.0 1.5 1.0 0.5 70 0.0 0.0 0.5 1.0 1.5 0.
171012402/WPMDH1152401J MagI³C Power Module Product Family VDRM - Variable Step Down Regulator Module I TYPICAL PERFORMANCE CURVES If not otherwise specified, the following conditions apply: VIN = 24V; CIN = 10µF X7R Ceramic; CO = 47µF, TAMB = 25°C Thermal Derating: VIN = 24V, VOUT = 12V @ θJA = 16°C/W Thermal Derating: VIN = 42V, VOUT = 24V @ θJA = 16°C/W 2.0 Output Current [A] Output Current [A] 2.0 1.5 1.0 0.5 0.0 1.5 1.0 0.5 0.
171012402/WPMDH1152401J MagI³C Power Module Product Family VDRM - Variable Step Down Regulator Module I TYPICAL PERFORMANCE CURVES If not otherwise specified, the following conditions apply: VIN = 24V; CIN = 10µF X7R Ceramic; CO = 47µF, TAMB = 25°C Load Transient Response VIN = 24V VOUT = 12V Load Step from 10% to 100% 200 mV/Div Load Transient Response VIN = 24V VOUT = 12V Load Step from 30% to 100% VOUT=12V 100 mV/Div VOUT=12V IOUT IOUT 1 A/Div 1 ms/Div 1 A/Div Current Limit vs.
171012402/WPMDH1152401J MagI³C Power Module Product Family VDRM - Variable Step Down Regulator Module I TYPICAL PERFORMANCE CURVES If not otherwise specified, the following conditions apply: VIN = 24V; CIN = 10µF X7R Ceramic; CO = 47µF, TAMB = 25°C Startup VIN = 24V, IOUT = 1.5A VOUT ENABLE 5V/Div 1 ms/Div Data Sheet Würth Elektronik eiSos GmbH & Co. KG - REV 0.
171012402/WPMDH1152401J MagI³C Power Module Product Family VDRM - Variable Step Down Regulator Module J CIRCUIT DESCRIPTION MagI³C 7 Steps to design the power application The next 7 simple steps will show how to select the external components to design your power application: 1. 2. 3. 4. 5. 6. 7.
171012402/WPMDH1152401J MagI³C Power Module Product Family VDRM - Variable Step Down Regulator Module J CIRCUIT DESCRIPTION causes the output voltage to rise and the voltage at the FB to exceed 0.8V. As long as the voltage at FB is above 0.8V, on time cycles will not occur. The ratio of the feedback resistors for a desired output voltage is: ( ) (2) These resistors should be chosen from values in the range of 1kΩ to 50kΩ.
171012402/WPMDH1152401J MagI³C Power Module Product Family VDRM - Variable Step Down Regulator Module J CIRCUIT DESCRIPTION ripple voltage and to avoid over-voltage protection during normal operation. The following equations can be used: (5) where is calculated using equation (16) below. ) ) (6) where AFB is the gain of the feedback network from VOUT to VFB at the switching frequency. As worst case, assume the gain of AFB with the CFF capacitor at the switching frequency is 1.
171012402/WPMDH1152401J MagI³C Power Module Product Family VDRM - Variable Step Down Regulator Module J CIRCUIT DESCRIPTION (10) )) The selection of RON and fSW(CCM) must be confined by limitations in the on-time and off-time for the COT control section. The on-time of the MagI³C power module timer is determined by the resistor RON and the input voltage VIN. It is calculated as follows: ) (11) The inverse relationship of tON and VIN gives a nearly constant switching frequency as V IN is varied.
171012402/WPMDH1152401J MagI³C Power Module Product Family VDRM - Variable Step Down Regulator Module J CIRCUIT DESCRIPTION The feed forward capacitor CFF, should be located close to the FB pin. Power Loss and Board thermal Requirements For example: ) , the device must see a maximum junction-to-ambient thermal resistance of: )) (17) This will ensure that the junction temperature of the regulator does not exceed in the particular application ambient temperature.
171012402/WPMDH1152401J MagI³C Power Module Product Family VDRM - Variable Step Down Regulator Module J CIRCUIT DESCRIPTION Thermal Resistance θJA [°C/W] Package Thermal Resistance θJA 4 Layer Printed Circuit Board with 35µm Copper 40 0LFM (0m/s) air 225LFM (1.14m/s) air 500LFM (2.54m/s) air Evaluation Board Area 35 30 25 20 15 10 5 0 0 10 20 30 40 50 60 Board Area [cm²] 2 For and only natural convection (i.e. no air flow), the PCB area can be smaller than 10cm .
171012402/WPMDH1152401J MagI³C Power Module Product Family VDRM - Variable Step Down Regulator Module J CIRCUIT DESCRIPTION This reduces any voltage drops on the input or output of the converter and maximizes efficiency. To optimize voltage accuracy at the load, ensure that a separate feedback voltage sense trace is made to the load. Doing so will correct for voltage drops and provide optimum output accuracy. 5: Provide adequate device heat-sinking.
1012402/WPMDH1152401J MagI³C Power Module Product Family VDRM - Variable Step Down Regulator Module K BLOCK DIAGRAM Power Module 0.47µF Linear Regulator CVCC CBOOST 15µH VOUT VIN HSS RON FB Controller/ Power Control/ Protection Circuitry LSS PGND SS EN AGND Data Sheet Würth Elektronik eiSos GmbH & Co. KG - REV 0.
171012402/WPMDH1152401J MagI³C Power Module Product Family VDRM - Variable Step Down Regulator Module L PIN CONFIGURATION Exposed Pad = PGND 3 4 5 6 7 FB 2 VOUT 1 SS Connect to AGND 6 EN AGND VIN RON 7 Top View 7 PIN PFM M DETAILED PIN DESCRIPTION PIN # PIN SYMBOL TYPE 1 VIN PWR 2 RON I 3 EN I 4 AGND PWR 5 SS I 6 FB I 7 VOUT O EP EP Exposed Pad PIN DESCRIPTION The supply input pin is a terminal for unregulated input voltage source.
171012402/WPMDH1152401J MagI³C Power Module Product Family VDRM - Variable Step Down Regulator Module N PROTECTIVE FEATURES OUTPUT OVER-VOLTAGE PROTECTION (OVP) The voltage at FB is compared to a 0.92V internal reference. If FB rises above 0.92V the on-time is immediately terminated. This condition is known as over-voltage protection (OVP). It can occur if the input voltage is increased very suddenly or if the output load is decreased very suddenly.
171012402/WPMDH1152401J MagI³C Power Module Product Family VDRM - Variable Step Down Regulator Module O APPLICATIONS The MagI³C power module for high output voltage is easy-to-use DC-DC solutions capable of driving up to a 1.5A load with exceptional power conversion efficiency, output voltage accuracy, line and load regulation. They are available in an innovative package that enhances thermal performance and allows for hand or machine soldering.
171012402/WPMDH1152401J MagI³C Power Module Product Family VDRM - Variable Step Down Regulator Module O2 APPLICATIONS CIRCUIT VIN VIN VOUT VOUT Module RON RON EN CFF FB AGND RFBT SS RENT CIN RENB CSS RFBB COUT Vout 24V 18V 15V 12V 5V RFBT 34kΩ 34kΩ 34kΩ 34kΩ 34kΩ RFBB 1.18kΩ 1.58kΩ 1.91kΩ 2.43kΩ 6.49kΩ RON 499kΩ 374kΩ 287kΩ 249kΩ 100kΩ 47µF 100µF CIN COUT 10µF 33µF 33µF CSS 47µF 4700pF CFF 0.
171012402/WPMDH1152401J MagI³C Power Module Product Family VDRM - Variable Step Down Regulator Module P PHYSICAL DIMENSIONS (mm) recommended soldering pad solder past recommendation 150µm Data Sheet Würth Elektronik eiSos GmbH & Co. KG - REV 0.
171012402/WPMDH1152401J MagI³C Power Module Product Family VDRM - Variable Step Down Regulator Module Q DOCUMENT HISTORY DOCUMENT HISTORY Description Revision Date 0.1 08.02.2013 Preliminary version 0.2 11.10.2013 Page 20: schematic corrected Data Sheet Würth Elektronik eiSos GmbH & Co. KG - REV 0.
171012402/WPMDH1152401J MagI³C Power Module Product Family VDRM - Variable Step Down Regulator Module CAUTIONS AND WARNINGS The following conditions apply to all goods within the product series of MagI³C of Würth Elektronik eiSos GmbH & Co. KG: General: All recommendations according to the general technical specifications of the data-sheet have to be complied with. The disposal and operation of the product within ambient conditions which probably alloy or harm the component surface has to be avoided.
171012402/WPMDH1152401J MagI³C Power Module Product Family VDRM - Variable Step Down Regulator Module IMPORTANT NOTES The following conditions apply to all goods within the product range of Würth Elektronik eiSos GmbH & Co. KG: 1. General Customer Responsibility Some goods within the product range of Würth Elektronik eiSos GmbH & Co. KG contain statements regarding general suitability for certain application areas.