Manualshelf

Installation Instructions

ManualsBrandsVulcan ManualsCommercial Equipment60SS-10BP 60" Liquid Propane Endurance Restaurant Range with 10 Open Top Burners, 2 Standard Ovens, 358,000 Total BTU, 30,000 Burner BTU and 4 Oven Racks in Stainless Steel
12345678910
- 4 -
VFLANGED-FEET/4
Set of four (4) flanged feet. Two (2) sets required for 48", 60", and 72" ranges.
CURBMNT-XL4
Curb mounting kit. Two (2) sets required for 48", 60", and 72" ranges.
CONNECT-CHALL
Inter-Plumb kit for connecting for Salamander/Cheesemelter to range.
INSTALLATION
UNPACKING
This range was inspected before leaving the factory. The transportation company assumes full
responsibility for safe delivery upon acceptance of the shipment. Immediately after unpacking, check for
possible shipping damage. If the range is found to be damaged, save the packaging material and
contact the carrier within 15 days of delivery.
Carefully unpack range(s) and place in the approximate installation position. Remove parts packed in a
small cardboard box from oven cavity or shipped separately in finishing kit.
If burner has been shipped using any package strapping devices, remove these before installing the
range.
Before installing, check the type of gas supply (natural or propane) to make sure they agree with the
specifications on the rating plate located on the inside of the kick panel. If the supply and equipment
requirements do not agree, do not proceed with the installation. Contact your dealer immediately.
If it is necessary to remove the door for access through a kitchen door, follow the instructions below for
removal of the door, and subsequent installation of the door.
DOOR REMOVAL
1. Open door.
2. Grasp door firmly at both sides.
3. Lift door upward and pull it out so bottom hinge tabs disengage.
* This may be easier to accomplish one side at a time.
4. Close door almost shut and lower slightly to disengage top hinge tab.
5. Pull door outward.
DOOR INSTALLATION
1. Grasp door firmly at both sides.
2. Starting with either LH or RH top hinge tab, angle door and slide top hinge tab into opening between
hinge stop roller and hinge stop pin.
3. Lift door up (compress door hinge as if opening the door) and position bottom tab downward about
30 degrees down from horizontal.
4. Push door inward, inserting downward angled bottom hinge tab into opening just above hinge stop
pin.
* Bottom hinge tab must enter chassis at downward angle to engage.
5. Bottom hinge tab should engage on hinge stop pin.
6. Open door and pull door outward until bottom hinge tab locks on hinge stop pin.
7. Repeat above steps for opposite side.
8. Open and close door to make sure door hinges are locked in place and operate smoothly.