Range User Manual

ManualsBrandsVulcan Materials ManualsOtherVULCAN G60C

F35425 (October 2005) Page 8 of 23

ENDURANCE SERIES GAS RANGES - REMOVAL AND REPLACEMENT OF PARTS

5. Remove the kick plate as outlined under

COVERS AND PANELS.

NOTE: Do not kink the capillary tube when straight-

ening the tubing for removal.

6. Slide the capillary tube and thermocouple out of

the bracket and straighten the tube so that it can

be passed through the holes in the oven liner.

7. Remove the capillary tube from all routing clips.

8. Carefully slide the capillary tube and

thermocouple through the holes in the oven.

9. Remove the control valve, capillary tube, and

thermocouple from the unit.

10. Reverse the procedure to install a new control

valve assembly.

NOTE: During installation do not kink the new

capillary tube when feeding it through the holes in the

oven. Excess tubing can be loosely wrapped.

OVEN PILOT ASSEMBLY

WARNING: DISCONNECT THE

ELECTRICAL POWER TO THE

MACHINE AND FOLLOW LOCKOUT /

TAGOUT PROCEDURES.

WARNING: SHUT OFF THE GAS BEFORE

SERVICING THE UNIT.

WARNING: ALL GAS JOINTS DISTURBED

DURING SERVICING MUST BE CHECKED FOR

LEAKS. CHECK WITH A SOAP AND WATER

SOLUTION (BUBBLES). DO NOT USE AN

OPEN FLAME.

The oven pilot assembly is attached to the burner

assembly behind the kick plate.

1. Remove the kick plate as outlined under

COVERS AND PANELS.

2. Remove the oven rack.

3. Remove the oven bottom.

4. Remove the oven left and right liner.

5. Remove the oven bottom heat shield.

6. Remove the screws securing oven pilot

assembly to the burner assembly.

7. Pull the pilot assembly out through the front of

oven.

8. Reverse the procedure to install the oven pilot

assembly.

OVEN BURNER ASSEMBLY