User’s Manual TM SPAN THE SPINOSAURUS TM © 2012 VTech Printed in China 91-002765-000 US
Hi Friend, You’re about to embark on a “dino-mite” adventure with me, Span the Spinosaurus™! Just so you know, I’ve been specially created just for you and am part of the VTech® Switch & Go Dinos™ crew! Switch & Go Dinos™ are a special breed of dinosaurs that transform from vehicle to dino in a few easy steps.
INTRODUCTION I’m Span the SpinosaurusTM, and I’m the biggest carnivore of all time! My huge size, long jaws, and sharp teeth make me a meat-eating machine. And if that doesn’t scare you, the massive sail on my back will! Let me give you some advice.
INCLUDED IN THIS PACKAGE • One VTech® SWITCH & GO DINOSTM: Span the SpinosaurusTM • One user’s manual ATTENTION: Pour la sécurité de votre enfant, débarrassez-vous de tous les produits d’emballage tels que rubans adhésifs, feuilles de plastique, attaches et étiquettes. Ils ne font pas partie du jouet. NOTE: Please keep the user’s manual as it contains important information. GETTING STARTED BATTERY INSTALLATION 1. Make sure the unit is turned OFF.
• Use new alkaline batteries for maximum performance. • Use only batteries of the same or equivalent type as recommended. • Do not mix different types of batteries: alkaline, standard (carbonzinc) or rechargeable (Ni-Cd, Ni-MH), or new and used batteries. • Do not use damaged batteries. • Insert batteries with the correct polarity. • Do not short-circuit the battery terminals. • Remove exhausted batteries from the toy. • Remove batteries during long periods of non-use.
3. STYLE BUTTON Press the Style Button to choose a pilot or change the dino eyes. 4. TALK BUTTON 5. SOUND BUTTON Press the Sound Button to hear cool sound effects. 6. VOLUME BUTTON Press the Volume Button to adjust the volume. 7. TAIL BUTTON Product Features Press the Talk Button to hear the dino or pilot talk. Press the Tail Button to make the dino chomp and roar. Note: The dinosaur’s head must be pulled all the way out in order for the Tail Button to work. 8.
9. LAUNCHERS Press the Launchers to launch the food discs. 10. DINO CAGE AND BABY DINO 11. RESCUE LIFT Use the Rescue Lift to carry the cage and other Switch & Go Dinos too. 12. REATTACHING THE DINO JAW If the dinosaur jaw falls off, please follow the steps below to reattach it. 1) Turn the dinosaur upside down and insert the cylinder on the side of the jaw into the hole on the underside of the head. 2) Fit the holes on each side of the jaw over the blue knobs under the head.
1. Plane shape. 2. Move the landing gear on the bottom of the plane back. 3. Move the sides of the tail in. Then move the whole tail down. 4. Rotate the nose of the plane down. 5. Pull the head out. 6. Rotate each of the wings 180 degrees so that they’re facing backwards.
8. Move the spine up. 1:1 Note: To change the dino back into a plane, reverse the order of the steps above. CARE & MAINTENANCE 1. Keep the unit clean by wiping it with a slightly damp cloth. 2. Keep the unit out of direct sunlight and away from any direct heat source. 3. Remove the batteries when the unit is not in use for an extended period of time. 4. Do not drop the unit on a hard surface and do not expose the unit to moisture or water.
NOTE: • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help. Note FCC information: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.