User`s manual

FCC, ACTA and IC regulations

FCC Part 15

This equipment has been tested and found to comply with the requirements for a

Class B digital device under Part 15 of the Federal Communications Commission (FCC) rules. These

requirements are intended to provide reasonable protection against harmful interference in a residential

installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and

used in accordance with the instructions, may cause harmful interference to radio communications. However,

there is no guarantee that interference will not occur in a particular installation. If this equipment does cause

harmful interference to radio or television reception, which can be determined by turning the equipment off and

on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

Changes or modiﬁcations to this equipment not expressly approved by the party responsible for compliance

could void the user’s authority to operate the equipment.

This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1)

this device may not cause harmful interference, and (2) this device must accept any interference received,

including interference that may cause undesired operation. Privacy of communications may not be ensured

when using this telephone.

To ensure safety of users, the FCC has established criteria for the amount of radio frequency energy that can be

safely absorbed by a user or bystander according to the intended usage of the product. This product has been

tested and found to comply with the FCC criteria. The handset may be safely held against the ear of the user.

Caution: To maintain the compliance with the FCC’s RF exposure guideline, the telephone base shall be installed

and used such that parts of the user’s body other than the hands are maintained at a distance of approximately 20 cm (8

inches) or more.

This Class B digital apparatus complies with Canadian requirement:

CAN ICES-3 (B)/NMB-3(B)

For body worn operation, this pendant has been tested and meets the FCC RF exposure guidelines when used

with the VTech accessories supplied or designated for this product. Use of other accessories may not ensure

compliance with FCC RF exposure guidelines.

FCC Part 68 and ACTA

This equipment complies with Part 68 of the FCC rules and with technical requirements adopted by the

Administrative Council for Terminal Attachments (ACTA). The label on the back or bottom of this equipment

contains, among other things, a product identiﬁer in the format US:AAAEQ##TXXXX. This identiﬁer must be

provided to your telephone service provider upon request.

The plug and jack used to connect this equipment to premises wiring and the telephone network must comply

with applicable Part 68 rules and technical requirements adopted by ACTA. A compliant telephone cord and

modular plug is provided with this product. It is designed to be connected to a compatible modular jack that is

also compliant. An RJ11 jack should normally be used for connecting to a single line and an RJ14 jack for two

lines. See the installation instructions in the user’s manual.

•