User Guide

EN - 9
English
Installation
Analogue 1-Line Hidden Base with
Cordless Colour Handset and Charger
- CTM-A2116
Analogue 1-Line Hidden Base
Base station installation
This section assumes that your network
infrastructure is established.
You can power the base station using a
compatible VTech power adapter. Install
the base station near a power outlet not
controlled by a wall switch. The base
station can be placed on a flat surface or
mounted on a wall in a vertical or horizontal
orientation.
To install the base station:
Plug one end of the telephone line cord into
the RJ jack on the rear of the base station
(marked by TO TEL), and plug the other end
of the cord into your telephone wall jack.
Connect the supplied power adapter to the
base station power jack.
Plug the power adapter into an electrical
outlet that is not controlled by a wall switch.
IMPORTANT INFORMATION
1. Use only a compatible VTech power
adapter. To order a replacement power
adapter, call [phone] or
email [e-mail].
2. The power adapter is intended to be
correctly oriented in a vertical or floor
mount position. The prongs are not
designed to hold the plug in place if it is
plugged into a ceiling, under-the-table or
cabinet outlet.