User Manual

23
2. While the handset is idle or in pre-dial, as
follows:
While the handset is idle the user can perform
a quick dial by holding down the desired quick
dial location key (0-9). If the location is empty
then
will be shown for a few seconds before returning to
the idle or pre-dial screen.
If the location does have an entry, then that
number will be added to any pre-dialed digits
and the phone will go off-hook and begin dialing.
Audio Volume
Audio volume is adjusted during an active call by
the following key sequence:
Pressing the volume or keys on the side of
the unit. Separate volume settings are
maintained for normal, handsfree and headset
modes. When the volume keys are pressed
during a call the screen will show:
As the volume is increase the number of blocks
shown will increase. As the volume is decreased
fewer blocks will be shown.
Ring Volume
The volume of the ringer signal can be adjusted by
the following key sequence:
1) Press SEL
2) Press the key until the following is shown
on the display.
3) Press SEL to enter the ring volume sub-
menu.
4) Enter volume 0 - 6, or adjust using and
keys. The current ring tone/melody is played
Basic Operation
Handset Settings