User Manual

The recommended C.G (Center of Gravity) location for the Stick is 89 ~ 91mm
Adjust the location of the battery pack as required to achieve this C.G location.
If necessary , add weight to either the tail or nose until the correct balance is achieve.
CG
WARNING ! Securely install the receiver and power pack, ensuring they will not come loose or rattle
during flight. Never fly before checking the Cg’s required position.
89 ~ 91mm
19- Balance
3-33/64” ~ 3-19/32”
ELEVATOR
AILERON
RUDDER
21-Pre-Flight check
RANGE TEST YOUR RADIO
Turn on the radio in your plane. With your plane on the ground, you should be able to walk 30 paces away
from your plane and still have complete control of all functions. If not, do NOT attempt to fly.
Be sure that your batteries are fully charged per the instructions included with your radio.
BEFORE FLYING
1-Fully extend the transmitter antenna.
2-Switch ON the transmitter.
3-Switch ON the receiver.
4-By moving the throttle control stick, ensure the carburetor opens and closes without effort.
FLYING
1-Take-off your airplane INTO THE WIND.
2-Do not fly your airplane above people standing around.
AFTER FLYING
1-Always land your airplane INTO THE WIND.
2-Switch OFF the receiver.
3-Switch OFF the transmitter.
AILERON STROKE
ELEVATOR STROKE
RUDDER STROKE
25/64”(10mm)
51/64”(20mm)
20-Control Surface
25/64”(10mm)
25/64”(10mm)
25/64”(10mm)
51/64”(20mm)
IMPORTANT:
Please do not clean your model with strong solvent or pure alcohol, only use liquid soap with
water or use class cleaner to clean on surface of your model to keep the colour not fade.