Manualshelf

Installation Guide

ManualsBrandsVon Duprin ManualsView All Von Duprin HardwareVon Duprin Thumbpiece Trim for 88 Series Vertical Rod Exit Device
12
INSTALLATION INSTRUCTIONS
PAGE NO.
1 of 2
REVISION
7 921250-00
1. Prepare door for exit device. See exit device
instructions for holes, line X-X, and center lines.
2. Prepare door for trim:
A. Transfer line X-X from inside (exit device
side) of door to outside (trim side) of door.
Use extra care if edge of door is beveled.
B. Locate and prepare all holes as shown.
For cutouts on inside face of door, see exit device instructions
LHR shown, RHR opposite
X
X
XX
1” ref.
1-1/4”
1-5/8”
1/4” dia.
3/8” dia., 4 places
Metal door: this side
Wood door: thru
Corresponds to
exit device
center line on
exit device
instructions
C
L
Metal
door
Wood
door
Outside face
of lock stile
Inside face
of lock stile
2-5/8”
Line X-X corresponds to line X-X on exit device instructions
3/8” dia.
Metal door: this side
Wood door: 1-5/8” deep
6”
1-5/8”
1/2” rad.
3-7/32”
6-7/16”
2-1/8”
15/16”
2-1/8”
15/16”
5/8”
TP trim only (omit for BE)
1-3/8” dia.
Metal door: this side
Wood door: 1-1/4” deep
6”
3-7/32”
6-7/16”
Metal door:
7/32” dia.
4 places
1/4”
C
Trim
L
C
Trim
L
1/8” 1/8”
880TP/TP-BE
(see other side for 880DT/EO/NL)
880TP/TP-BE (see other side for 880DT/EO/NL)
IMPORTANT
!
Note that trim center line is offset
from line X-X by 1/8” as shown.
880DT/EO/NL/TP/TP-BE TRIM
FOR 44 AND 88 RIM DEVICES
3. For TP trim, install cylinder in trim. Cut
cylinder tailpiece to extend out of exit
device side of door as follows:
44 Rim device: 3/16” to 1/4” extension
88 Rim device: 5/8” to 3/4” extension
4. Cut thumbpiece to extend 5/8” to 3/4”
out of exit device side of door.
5. Apply trim.
6. Apply exit device.
Copyright © 2007 Ingersoll-Rand
Company Limited

Summary of content (2 pages)