User manual

Table Of Contents
The remote desktop must have View Agent 6.2 or later, or Horizon Agent 7.0 or later, installed. For best
performance, the virtual machine should have at least 2 GB of RAM and 2 vCPUs. This feature might
require good network conditions, such as a bandwidth of 1000 Mbps with low network latency and a
low package loss rate.
N When the remote desktop screen resolution is set to 3840 x 2160 (4K), items on the screen might
appear smaller, and you might not be able to use the Screen Resolution dialog box in the remote
desktop to make text and other items larger. In this scenario, you can set the client machine's DPI to the
proper seing and enable the DPI Synchronization feature to redirect the client machine's DPI seing to
the remote desktop.
n
If you use Microsoft RDP 7, the maximum number of monitors that you can use to display a remote
desktop is 16.
n
If you use Microsoft RDP display protocol, you must have Microsoft Remote Desktop Connection
(RDC) 6.0 or later installed in the remote desktop.
Select Specific Monitors in a Multiple-Monitor Setup
You can use the selective multiple-monitor feature to select the monitors on which to display a remote
desktop window. For example, if you have three monitors, you can specify that the remote desktop window
appears on only two of those monitors. By default, a remote desktop window appears on all monitors in a
multiple-monitor setup.
You can select up to four adjacent monitors. The monitors can be side by side, stacked two by two, or
stacked vertically. A maximum of two monitors can be stacked vertically.
This feature is not supported for remote applications.
Procedure
1 Start Horizon Client and log in to a server.
2 In the desktop and application selection window, right-click the remote desktop and select .
3 Select PCoIP or VMware Blast from the Connect Via drop-down menu.
4 Select All Monitors from the Display drop-down menu.
Thumbnails of the monitors that are currently connected to your client system appear under Display
seings. The display topology matches the display seings on your client system.
5 Click a thumbnail to select or deselect a monitor on which to display the remote desktop window.
When you select a monitor, its thumbnail turns green. A warning message appears if you violate a
display selection rule.
6 Click Apply to save your changes.
7 Click OK to close the dialog box.
8 Connect to the remote desktop.
Your changes are applied immediately when you connect to the remote desktop. Your changes are
saved in the Horizon Client preferences le for the remote desktop after you exit from Horizon Client.
Use One Monitor in a Multiple-Monitor Setup
If you have multiple monitors but want a remote desktop window to appear on only one monitor, you can
congure the remote desktop window to open on a single monitor.
This preference is not supported for remote applications.
Using VMware Horizon Client for Windows
86 VMware, Inc.