Fan-Forced Heater USER MANUAL
CONTENTS Important Instructions 1 Specifications 2 Safety Information 3 Locating Heater 4 Pre-installation 5 Installation 5 Operating Instructions 6 Maintenance 13 Replacement Parts 14 Troubleshooting 15 Warranty 16
IMPORTANT INSTRUCTIONS IMPORTANT INSTRUCTIONS When using electrical appliances, basic precautions should always be taken to reduce the WARNING TO PET OWNERS: risk of fire, electric shock, and personal injury, including the following: The health of some small pets, including birds, is extremely sensitive to the fumes produced 1. Read all instructions before installing or using this heater. during the first-time use of many appliances. These fumes are not harmful to humans but we 2.
SAFETY INFORMATION Warning THIS HEATER REQUIRES HARDWIRE INSTALLATION (NO PLUG). THE INSTALLATION OF THIS PRODUCT MUST BE CARRIED OUT BY A CERTIFIED ELECTRICIAN AND IN ACCORDANCE WITH ALL LOCAL AND NATIONAL ELECTRICAL CODES. NOTE: COMPATIBLE WITH A 240V LINE VOLTAGE DOUBLE POLE WALL THERMOSTAT. MUST BE INSTALLED BY A CERTIFIED ELECTRICIAN. LOCATING HEATER Install the heater away from traffic areas, maintaining the clearances shown in Figure 1 (below). The air flow direction should not be restricted (e.g.
PRE-INSTALL ATION INSTALLATION NOTE: If the heater is to be swivelled either to the right or left, it is recommended that a washer is added to both sides of the bracket. A longer lag bolt may be required to secure the unit properly. See Figure 3a. Wood Ceiling Wood Ceiling Washer Garage Heater Mounting Bracket x1pc x1pc Washer Bracket 3 8 in. Diagonal Bracket 3 8 in. Diagonal Lag Bolt Figure 3a.
INSTALLATION INSTALLATION ADJUSTING THE AIRFLOW DIRECTION CONNECTING THE POWER 1. To rotate the unit if it has been installed with a single lag bolt (as shown in Figure Temperature Regulator 4a), simply turn the entire heater as needed. The unit cannot be rotated horizontally if it has been installed with 2 lag bolts. L1 240AC or 208AC 60HZ 2. To tilt the unit vertically, loosen the bracket screws (see Figure 4). ACL1 L2 BG 3. Adjust the louvers to the desired position (see Figure 5).
INSTALLATION INSTALLATION 3. The external temperature control (external thermostat) should be in accordance with the requirement of the UL or ETL standard. 4. The lead wire of the external temperature control (external thermostat) must not be less than 22 AWG. TO PROTECT THE HEATER When starting the heater, slowly turn the temperature control clockwise slowly to terminal, Warning HIGH TEMPERATURES - RISK OF FIRE.
OPERATING INSTRUCTIONS OPERATING INSTRUCTIONS 2. Heater Control Button: Warning This button adjusts the 3 heating levels: OFF, FA (Fan Only), AU: LOW (6400W displays "L") THE HEATER MUST BE PROPERLY INSTALLED BEFORE IT IS USED. or High (8500W displays "H"). 1 6 2 4 5 3. Temperature/Timer Display: This LED display shows the set point for the temperature and timer functions. When either of these functions is activated, the display will show the set point for about 10 seconds and then fade to black.
OPERATING INSTRUCTIONS 6. Fahrenheit/Celsius Button: REPLACEMENT PARTS Part Descriptiom Part# Part Descriptiom Part# 1 Back mesh HS1250-06001 9 Heater HS1285-06001 is set. When the garage heater is turned on, the temperature is displayed in Fahrenheit (F).
TROUBLESHOOTING Problem Display Code Display shows "EE" The product does not have electricity entering Unit is not heating The heater button is invalid Display shows "FA" and blows cold air The heater will not start The heater will not start Garage heater emits a burning smell 15 WARRANTY Root Cause Corrective Action The thermostat sensor is broken or disconnected. Please call customer service. The overheat protection has activated.