Manualshelf

User and Care Instructions

ManualsBrandsVitamix ManualsBlenders64585
12345678910
USE AND CARE INSTRUCTIONS
Read and save these instructions.
Note: When properly installed, the tamper holder will not interfere with blender operation.
The tamper holder can be attached to the frame either on the left or right side of the motor
base as you choose.
1. Clean the parts by hand with warm, soapy water or in the top rack in the dishwasher before
assembling.
2. Choose a side of the motor base to install the tamper holder.
3. Lift up the blender base. Put the tab on the tamper holder into the opening in the blender frame.
Lower the blender base back onto the counter.
4. Put the tamper holder cup onto the tamper holder base. Twist the tamper holder cup clockwise
to lock into place.
5. Make sure the blender is sitting flat and steady (no rocking side to side) before blending.
Proper installation
(flush against motor
base)
Note: When installed properly, the inside flat surface
of the tamper holder cup will sit flush with the side
of the blender (See photo).
6. Remove the tamper holder from the blender
regularly to clean. To remove the tamper holder
cup, rotate the cup counter-clockwise.
7. To remove the tamper holder from the machine
base, lift up on the motor base and remove the
tamper holder base.

Summary of content (10 pages)