ASSEMBLY GUIDE Rosewood Arbor VA68894 VER 1.
X 1-800-282-9346 hello@wearevita.com 8:00 AM - 5:00 PM EST wearevita.
IN THIS GUIDE PARTS LIST 4 TOOLS YOU WILL NEED - PRODUCT DIMENSIONS 5 STEP 1 AND 2 6 STEP 3 AND 4 7 STEP 5 AND 6 8 STEP 7 AND 8 9 STEP 9 AND 10 (TEMPORARY INSTALLATION) 10 STEP 11 (PERMANENT INSTALLATION) 11
PARTS LIST PRE-ASSEMBLED SIDE PANEL - 12004 - X2 POST TRIM 12001 - X4 ARCH KEYSTONE 12000 - X2 RIGHT ARCH - 12002 - X2 WOOD BLOCK - X1 LEFT ARCH - 12043 - X2 ARCH RAFTER - 12003 - X6 METAL GROUND STAKES - 12006 - X4 20071 - SCREW A - 1 1/4IN (3.18CM) - X8 - TO SECURE POST TRIM CAPS TO ARBOR POSTS 20064 - SCREW B - 1 1/4IN (3.18CM) - X8 - TO ATTACH METAL STAKES TO ARBOR 20063 - SCREW C - 1 3/4IN (4.
TOOLS YOU WILL NEED PRODUCT DIMENSIONS 26.5IN (67.3CM) 88.7 (225.3CM) 84.5IN (214.6CM) 42IN (106.7CM) 47IN (119.4CM) 20IN (50.8CM) 24IN (60.9CM) VER 1.
1 12002 - x2 12043 - x2 12043 x2 12000 - x2 12002 x2 2 6 20067 - x4 E VER 1.
3 20063 - x2 C Align central trim at arch marking 4 20063 - x12 C 12003 - x6 Stapled side of archs have to face each other, space between arches is 20in(50.8cm) VER 1.
5 12001 - x4 Screw holes to face inside of arbor 6 8 VER 1.
7 8 20065 - x8 D 20071 - x8 A x1 ! Use wood block provided to help you hold post trim in place! Repeat for each trim VER 1.
9 20064 x8 B 12006 - x4 10 A Temporary Installation Carefully push arbor stakes into desired ground area 10 VER 1.
B Permanent Installation For a permanent installation, measure four 8in (20.3cm) holes in diameter, 44 1/2in (113cm) apart by 22in apart (56cm), from center to center. Dig each hole 14in (36cm) deep. 44 1/2in (113cm) 22in (56cm) Fill excavated holes with mixed concrete and carefully lift arbor into place. Plumb and level the arbor. The posts should not be set in the concrete. Make sure to support bottom part of you lattice with bricks until concrete has set. This will stop your arbor from sinking.
