Installation Sheet
1. Carefully remove all parts from the box.
2. Feed the fixture wire and ground wire pass through the rod (H), then thread the rod (H)
to the top of fixture body (I).
3. Feed the fixture wire and ground wire pass through the collar ring (G) and canopy (F)
and rod (E). Then thread the rod (E) to the rod (H).
4. Install the mounting plate (B) to the juntion box with mounting screws (C) provided.
5. Hang the rod (E) with top end ball provided on the mounting plate (B) and seucre with
set screws (D) by using the wrench.
6. Connect the fixture ground (bare) wire with the ground wire from the junction box using
wire nut (A). If your house does not have ground wire, then attach this wire to the
green grounding screw inside of the outlet box.
IT IS IMPERATIVE THAT THIS FIXTURE BE GROUNDED.
7. Connect the fixture Neutral wire (ribbed) with the neutral wire (White) from the junction
box using wire nut (A).
8. Connect the fixture Hot (smooth, marks with words) wire with the hot wire (Black) from
the junction box using wire nut (A).
DO NOT REVERSE THE HOT AND NEUTRAL CONNECTIONS OR SAFETY WILL
BE COMPROMISED.
9. Tuck these wire connections neatly into the outlet box.
10. Put canopy (F) flush to the mounting plate (B) and secure with collar ring (G).
11. Attach the alabaster disk (L) with metal parts (K) to the bottom of the fixture body (I)
and secure with screws (J).
12. Installation is complete, turn on power at fuse or circuit breaker.
***Clean with a dry, soft cloth only. Use no harsh abrasives or chemical agents.
Melange Medium Floating Disc Pendant
Item # KW 5612
WE RECOMMEND INSTALLATION OF THIS LIGHTING FIXTURE BE DONE BY A
LICENSED ELECTRICIAN.
WARNING***SWITCH OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN
FUSE BOX/CIRCUIT BREAKER BEFORE INSTALLATION.
INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS ANY
DAMAGE OR OBVIOUS DEFECT. DO NOT INSTALL.
ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED.
NOTE: CAREFULLY UNPACK EACH PIECE IN TOP LAYER OF PACKING PRIOR TO
REMOVING. RETAIN ALL PACKING MATERIAL UNTIL INSPECTION AND
INSTALLATION ARE FINAL.
DAMP
L
I
S
T
E
D
C
US
Intertek
CM
junction box
A
B
C
D
F
G
E
H
I
Safety cable
Cable lock nut
TO assemble safety cables:
1.Join fixture safety cables with safety
cable from ceiling.
2.Wrap both safety cable around the
cable lock nut.
3.Insert screws into both holes on cable
lock nut,secure screws with screwdriver.
4.Push the cable lock nut into outlet box.
wrench
K
L
J