Installation Sheet

ASSEMBLY INSTRUCTIONS

WE RECOMMEND INSTALLATION OF THIS LIGHTING FIXTURE BE DONE BY A

LICENSED ELECTRICIAN.

WARNING *** SWITCH OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN

FUSE BOX/CIRCUIT BREAKER BEFORE INSTALLATION.

INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS

ANY DAMAGE OR OBVIOUS DEFECT, DO NOT INSTALL.

ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED.

1. Attach chain (F) to top loop (G).

2. Attach chain (F) to bottom loop of connection rod (E).

3. Afﬁx mounting strap (A) onto ceiling outlet box and secure with mounting

screws (B).

4. Thread top nipple of connection rod (E) into the center hole of canopy (C)

and secure with nut (D).

5. Attach the ground wire (bare wire) from the ﬁxture to the ground junction

box wire (usually green or copper wire). Fasten together with a plastic wire

connector and wrap the connection with electrical tape. Be sure no wire

strands are exposed.

6. Connect the neutral wire from the ﬁxture (ridges molded wire) to the neutral

wire from the junction box (usually white). Fasten together with a plastic wire

connector and wrap the connection with electrical tape.

BE SURE NO WIRE STRANDS ARE EXPOSED.

7. Connect the hot wire from the ﬁxture (smooth wire) to the hot wire (usually

black) from the junction box. Fasten each together with a plastic wire

connector and wrap the connection with electrical type. Be sure that no wire

strands are exposed.

DO NOT REVERSE THE HOT AND NEUTRAL CONNECTIONS

OTHERWISE SAFETY WILL BE COMPROMISED.

8. Attach canopy (C) to the afﬁxed mounting strap (A), secure by threading the

nipple of connection rod (E) to center hole of mounting strap (A).

9. Slide shades (H) onto the socket tubes.

10. Insert light bulbs (NOT INCLUDED) into the sockets.

11. Restore power and test ﬁxture.

DRY

Medium Enamaled Chandelier

Item # BBL5081