User's Manual

D-306082 MP-840 PIR ZB 3
3.2 Installation Procedure
1. Mount the bracket on the wall
2. Press in the point marked “F” in the drawing and separate the cover from the base
3. Insert the battery while observing polarity.
-OR-
If battery is already installed, pull the activation strip that protrudes from the front of the detector.
4. Return the cover to the base until a click is heard (the snap is closed).
5. Secure detector with screw (optional).
6. Align the detector with the bracket.
7. Slide the detector upward until a click is heard.
Note: It is recommended to wait about 1 minute after battery removal, before inserting the new battery.
Caution! Risk of explosion if battery is replaced by an incorrect type. Dispose of used battery according to the manufacturer's instructions
MP-840 shall be installed in accordance with the Standard for Installation and Classification of Burglar and Holdup Alarm Systems, UL 681
Figure 3 – Bracket Mounting
Figure 4 – Opening the Unit
Figure 5a – Battery Insertion
Figure 5b – Battery Activation
Figure 6 – Replacing Cover
Figure 7 – Securing with Screw
Figure 8 – Mounting Detector on Bracket
A. Surface mounting
B. Corner mounting
C. For back tamper
D. Cover
E. Base
F. Press in this point