Installation Guide

STEP 2
screwdriver,
nail punch
STEPS 1, 3, 6
tape measure,
t square, or drywall
t square suggested
STEPS 3, 6
non abrasive clamp,
masking tape, or
non marking tape
STEPS 4, 5, 6, 7
spline tool, with a
concave, and
convex roller
STEPS 5, 6, 7
spline material
STEP 7
matte knife,
or box cutter
razor edge
concave
convex
Suggested tool list and steps when to use them
Installation Guide
STEP 1
VisiScreen comes in a 3’ width with a single visi marker, and a 4’ width with two visi markers woven to be framed vertically for
installation with your door. It is suggested that the visi marker lines are arranged running vertical to the door frame, so that people and
pets at all heights will see the visi marker. The woven design can be placed in dierent vertical positions depending on your preference
of placement. VisiScreen suggests that the marker be installed 10” to 14” away from the screen door handle edge.
can be placed with a variation of suggested visi marker placements
3’ width roll
3’ door
3’ width roll
3’ door
4’ width roll
3’ door
4’ width roll
4’ door
centered 10” from handle 10” from handlecentered
STEP 2
After removing your screen door from the sliding door frame, nd a clean at
surface where you can work on installing your new VisiScreen door. The rst
step will be to remove the spline. The old screen is held in the frame by the
plastic or rubber spline that runs along the channel around the perimeter of
the frame. Use a nail punch or other sharp semi pointed object to loosen the
end of the spline and pull it up from the channel and out of the frame. After
the spline is removed the old screen should come out easily. This is a good
time to clean your frame before installing you new VisiScreen mesh.
spline material
being pried
up from the
sliding door
frame before old
screen removal