Installation guide

ADJUSTING THE SETTINGS IN THE SCAN MANAGER PRO 53
A new Scan Info box on the lower left portion of the Scan Manager
Pro shows the information for the new area. You can select multiple
areas. A Scan Info box opens for each one.
The following figure shows an example of a manually selected area.
4. If the dotted line is not exactly where you want it, put the pointer
on the line and drag the mouse.
To use the pointer to drag the line, make sure the pointer button is
selected at the top of the window.
5. To rotate the selected area 90 degrees, click Rotate 90 Degrees and
select either Left or Right.
Note: When you manually select an area, the settings on the other
panels are for that selected area, not the whole image. For example,
the histogram on the resolution panel and the response curve on the
brightness and contrast panel refer to only your newly selected area.
A new Scan Info box for the
area selected on the image.
The selected scan area.